Rlc Definition and 435 Threads

Homework Statement Find the current through the resistor in the following RLC low-pass circuit: (there's an EMF missing on the left side, V=Vo cos(omega*t) Homework Equations Kirchoff's loop ruleThe Attempt at a Solution By using Kirchoff's loop rule and the junction rule, i get two...

A series RLC circuit is connected to a 5 V supply, the frequency of the supply is adjusted to give a maximum current of 11.9 mA at 2.5 kHz. The Q factor is 70. Determine the component values of the circuit. R= 5/.0119=420.2 Ohm Q = (1/R)*(sqrt L/C) 70 = (1/420.2)*(sqrt L/C) 70/(1/420.2)=...

Voltage V(t)=V1 Re{eiwt} produces a current I(t)=I1 Re{e(iwt+θ). Determine I1 and θ. The circuit is AC so do I treat it the same as an SHM question? Is π/2? And what do I need to do to find I1? I don't know where to start.

Homework Statement Hello all, Representing RLC circuits via differential equations is rather new to me, in fact differentials as an entirety are new for me. Essentially I am looking for clarification regarding this type of question and whether or not I am doing it right. Thanks in advance...

Hi, I need to write a c++ program that calculates the total impedance of a simple RLC circuit. I'm given the values of each component (resistance, coil, condenser). The programming part is not a issue however I can't find the formulas for the impedance on the internet. Can someone help me out...

hi i have a textbooks that says that if you have a driven RLC at its resonance frequency and now you increase the inductance, then you would measure a phase difference between the external emf and the voltage at the capacitor that is now greater than pi/2 unfortunately, i do not know how to...

Not really sure whether this question belongs here or not (if it doesn't, help move?). So I was reading my electronic circuits textbook and am at the section of underdamped RLC unforced response, and the book mentions the natural response as v_{n} = e^{-\alpha\cdot t}(A_{1}\cdot...

The link below shows a circuit and the s-domain equation for I1(s) that I have derived; My question is on the portion of the equation containing the "(s+a)" terms. I am trying to arrive at the time-domain equation for I1(s) but instead of arriving at the Laplace transform pair shown in the...

Homework Statement An RLC circuits consists of R1 a 10-ohm resistor, R2 a resistor that takes 50 W, C1 a capacitor with 5-ohm reactance, and L1 an inductor that takes 100 var. Find the value of R1, R2, and Xl (inductive reactance).Homework Equations P = (I^2)R Xc = 1/(2∏fC) Xl = 2∏fL Z =...

I am having difficulties with phasor diagram for Is and Vs of an parallel RLC circuit. I have calculated all values but not sure how to use phasors. Impedance Z has angle +65°. Current Isupply +30° and Vsupply is Z*Is= Vs at angle 95° But with parrallel network V is the reference so I guess it...

Homework Statement Please check picture http://i.imgur.com/YMQBR.png Homework Equations The Attempt at a Solution Shouldn't all the energy be 0 at beginning? Thanks!

Hi there, we recently completed a laboratory session on MATLAB relating to an RLC Circuit and arrive at a code and relevant inputs and got our graphs as shown below. I was just wondering if anyone know if these are correct and make any sense? Or any other comments appreciated. We also have...

[FONT="Times New Roman"]Homework Statement Find impedance and Io. draw phasor diagram for rlc circuit V = 120cos(2π525t) where R = 10Ω, C = 1μF, L = 100mH, Vo = 120V Homework Equations Z = √(R2 + (ωL-1/(ωC))^2) = √(10^2 + (2π * 525 Hz * 100 mH - 1/(2π * 525 Hz * 1 μF ))^2) = 28.525Ω...

Quick Question... Given: Can I still use the general impedance equation for parallel RLC circuits even though the resistors are not in parallel with the other components? Substituting the two resistors for a single resistor with the equivalency resistance?

Hey, Quick question for you guys. How do you find alpha (damping coefficient, Neper frequency) for a circuit that's not strictly parallel or in series? For instance, α for a series RLC circuit is R/2L whereas α for a parallel circuit is 1/2RC; but what if it's different? Homework...

Homework Statement A series RLC circuit has an electromotive force given by E=200e^(-100t) V, a resistor of 80 ohms, an inductor of 0.2 H, and capacitor of 5x10^-6 F. If the initial current and charge on the capacitor are zero, find the current at any time t>0. Homework Equations ...

A series RLC circuit has an electromotive force given by E=200e^(-100t) V, a resistor of 80 ohms, an inductor of 0.2 H, and capacitor of 5x10^-6 F. If the initial current and charge on the capacitor are zero, find the current at any time t>0. How on Earth do i start this?!

Homework Statement For RLC circuit determine and solve differential equation. R, L, C, E0 values are constants, E = E(t) = E0*sin(ω*t) (E is marked as V in the image). Then make program which calculates values of I(t) when R, L, C, E0, ω are given. In short, I need to get function I(t), so I...

I have been given the task of building an RLC circuit that is driven at 10kHz, has an output amplitude of 1/sqrt(2) and is 45 degrees out of phase from the input voltage. I am not really even sure where to get started. Any tips will be greatly appreciated.

how to get this equation: Vout/Vin = [RL]/[-[ω][/2]+jω(R/L)+1/(LC)]

Edited for assignment purposes...

Homework Statement Given a series RLC circuit with a sinusoidal voltage input, find the effective voltage across each element. Given: 1) If the effective value of the source voltage is 1 V, the effective value of the current is 1 amp. 2) i(t) lags v(t) by 45 degrees 3) L=1H 4) w=2...

Homework Statement Hey guys. So we've been working on a RLC circuit, where the subject is oscillations. We accomplished to work out a differential equation, for this specific circuit, however solving it is a completely other part of the problem. We're completely stuck here and hopefully...

I'm looking at this question and I can't seem to come up with an answer, don't the VL (inductive voltage) and Vc (capacitor voltage) just cancel each other out leaving you with Vr (resistance voltage) as the source voltage, but I don't see why VL and Vc are much higher than the source voltage...

Homework Statement Consider a RLC circuit. a) Suppose the parameters are chosen to give critical damping. The capacitor is charged to a voltage of V₀ and at time equal to zero the switch is closed. Find the time at which the magnitude of the current reaches a max, and find the value of the...

the general form of state space output is y=cx+du which means that output is linear combination of state variables and inputs my question is can we write output in this form when our output is not combination of state variable for example in rlc circuit state variables are vc and IL now if we...

Consider the circuit show below, where V1 = V_{peak}sin(\omega t - 36^\circ) http://img195.imageshack.us/img195/9687/rlc.png I wish to find an expression for I in the time domain and in phasor form and then sketch the magnitude/phase vs frequency plots. I already managed to get a solution...

Does anyone have a formula for the current in a series RCL circuit, if I have the: resonance frequency, current at resonance, capacitance (only one resistor, one capacitor, and one inductor), the voltage of the battery attached, and resistance?

oké, I'm ghaving a hard time with this one, bt it should be really simple acutally: picture shows RLC circuit: by kirchhoff law we can stat that: +V-R*i(t)-(1/C)*integral(i*dt)-L*(di/dt)=0 I do understand V, R*i(t) and )-(1/C)*integral(i*dt), because those voltage physically...

1. Consider a series RLC circuit. The applied voltage has a maximum value of 160 V and oscillates at a frequency of 53 Hz. The circuit contains a variable capacitor, a 760 Ω resistor, and a 5.7 H inductor. Determine the value of the capacitor such that the voltage across the capacitor is...

Homework Statement here is the circuit >>> http://www.4shared.com/photo/F3ewfm_3/22_online.html the whole question is here >>> http://www.4shared.com/document/Qwxgzq78/Circuits_for_Modeling.html whats assigned to me is #22. anyways, what we need to get here is the differential equations...

Homework Statement I'm trying to determine this insane circuit's |Z| so I can use an AC voltage to find the current as a function of time. This is my circuit (the switch is closed, and ignore the values): http://i.imgur.com/mA55I.png Homework Equations Impedances for each of the RLC...

Hey everyone, Ive been learning RLC circuits recently and all is ok now in the understanding side of things. We have also been learning about AM transmition and LCAM. Also how LCAM uses just a diode, capacitor and resistor to demodulate as that circuit will trace the peaks and recreate the...

Hi guys I really need some help to finish this on time, 1. A circuit with V volts and a 2 ohm resistor and a 2mH inductor and a 500uF capacitor in series. There is a graph of current through circuit over time, starting at 0 current icnreases to 20 amps in 1 mS stays there for 1 ms then goes...

Hi! Recently I did an experiment of an RLC circuit nearing resonance, and I found a substantial amount of loss of both current and voltage (30%). (More so than a different kind of AC circuit) My question is, why is this so? Or is this just a coincidence/human error? Some of...

Homework Statement Consider an RLC circuit with very large Resistance. a) when t = 0, q(0) = 0 b) When t = TL q(TL) = 2Q(1+e)-1cosh(TL/TC) Where TL and TC are the inductive and capacitive time constants, respectively. Show that the charge as a function of time is given by: q(t) =...

Homework Statement Solve the differential equation(for voltage uc(t) on the end of the capacitor in some electric circuit) http://pokit.etf.ba/get/402e740f4c35317784c20c0acd656de5.jpg for independent starting conditions http://pokit.etf.ba/get/?f840b445d268567428ada50ed466c4f6.jpg and...

hi guys I am trying to fined Vo and Io using mesh analysis for the following cct The formulas I made from the cct using mesh analysis don't seem right here is what I have- loop1 2(I1 - I2) = 0 loop2 2(I2 - I1) + I2(j4) - 3Vo = 0 loop3 3Vo + I3(-2j) = 0 and I1 = 4<-30 vo...

Consider a series RLC circuit. The applied voltage has a maximum value of 120 V and oscillates at a frequency of 81 Hz. The circuit contains a variable capacitor, an 820 \Omega and a 3.7 H inductor. Determine the value of the capacitor such that the voltage across the capacitor is out of phase...

Homework Statement At resonant frequency of 2,459 Hz for an RLC circuit, average power of circuit is 74 Watts when connected to a voltage source with a maximum voltage of 58 volts. If capacitance is 3 micro-Farads, what is maximum current, in amps, at 1,759 Hz? Answer is 2.14.Homework Equations...

Homework Statement Calculate the impedance Zab across ab. w=0.75 Hz wo=1 Hz. L=1 H R=1 Ohm C=1 F Inductor and Capacitor are in series, and together are in parallel with the resistor. circuit looks like a capital A, but square on top, and rotated 90 degrees clockwise.. if that...

I am trying to model an oscilloscope probe(active probe). The voltage source in the circuit is from the device under measurement. Let's say a 100MHz clock. The probe signal and ground lead inductance are represented by 2 inductors, then a small series resistor. I made up the value of the...

Electrical oscillations are initiated in a series circuit containing a capacitance C, inductance L, and resistance R. a) If R << \sqrt{\frac{4L}{C}} what time interval elapses before the amplitude of the current oscillation falls to 50.0% of its initial value? b)Over what time interval does...

Homework Statement I'm struggling to figure out what vectors I use for my phasor diagram for an RLC series circuit. Homework Equations VC = 1/j\omegaC VL = j\omegaL VR = IZ The Attempt at a Solution I know how to add vectors, so that's not a problem, transfer my circuit from the time...

Guys, Let's suppose we have RLC series circuit feeded by tension source initially with no energy stored. When we apply an unitary step of tension at t=0 at the terminals of the circuit, we observe a current of i(t)=(125/24) * exp(-700t)* Sin(2400t) mA that goes around the circuit for...

The energy of an RLC circuit decreases by 1.00% during each oscillation when R=2.00 ohms. If this resistance is removed, the resulting LC circuit oscillates at a frequency of 1.00 kHz. Find the values of inductance and capacitance.

Hello All, I have a bit of a problem with a series RLC circuit with no supply voltage. In the process of actually solving the second order differential equation for the voltage across the capacitor I have lost a handle on what it actually represents in terms of the circuit. I have attached...

What type of power rating does a wattmeter measure in an AC RLC circuit? Is the power measured the apparent power or active power, and is this reading the rms value? Also which current value is taken by an ammeter in an AC rlc circuit? is this also rms value?

I have design this circuit from the book on the software "Electronic Work Bench" but see the 1st peak voltage in the attached image, why it is in Giga Volts ? the 1% of 1st peak voltage should be equal to the last peak voltage but this condition is not fulfilling here ...why ? i have...

Homework Statement I did an experiment using an RLC circuit (in series) and an oscilloscope to determine the resonance frequency and amplitude (in volts) of my components (R total = 2300ohm, L = 0.081H, C = 1.5E-8F). I plotted all the data I collected (V vs. f) and got a nice response curve...