Atomic radius - core charge vs energy level

AI Thread Summary
The discussion centers on the factors influencing atomic size, particularly comparing beryllium and nitrogen. It highlights that beryllium has a smaller atomic radius than lithium due to a greater core charge. However, when comparing nitrogen to beryllium, nitrogen has a higher core charge but occupies the 2p subshell, while beryllium only has electrons in the 2s subshell. This leads to the conclusion that nitrogen has a smaller atomic radius than beryllium, primarily due to its core charge. Additionally, the use of hydrogen-like radial wavefunctions is mentioned as a qualitative tool to understand atomic radius behavior, although caution is advised in applying this concept beyond small atoms. The radial probability distributions for 2s and 2p states are also referenced, indicating that their maximum probabilities are similar, further complicating the comparison of atomic sizes.
.....
Messages
53
Reaction score
0
which one is more important in determining the size of an atom?

for example - Berilium has a smaller radius than Lithium because it has a greater core charge, but what about Nitrogen vs Berilium? Nitrogen has a greater core charge, but it has electrons in the 2p subshell whereas Berilium only goes to 2s.

Thanks in advance
 
Chemistry news on Phys.org
Hi ...,

Nitrogen has smaller radius than Berylium because of the core charge.

Hidrogen-like radial wavefunctions, although not valid for this case, can be used to qualitaively examine the behaviour of the radius (only in this little atoms, be carefull with this). If you look at the radial probability of a 2p state the maximum is not at higher radius value than the 2s, they are similar.

This is a 2s hidrogen-like radial probability graphic (for Z=4) and the corresponding contour plot in the xy plane, and the 2p plot for Z=7. Look at the maximums of prob. but don´t forget theese are hidrogen-like functions
 

Attachments

  • 2s plot.jpg
    2s plot.jpg
    6 KB · Views: 534
  • 2p plot.jpg
    2p plot.jpg
    6.3 KB · Views: 564
I want to test a humidity sensor with one or more saturated salt solutions. The table salt that I have on hand contains one of two anticaking agents, calcium silicate or sodium aluminosilicate. Will the presence of either of these additives (or iodine for that matter) significantly affect the equilibrium humidity? I searched and all the how-to-do-it guides did not address this question. One research paper I found reported that at 1.5% w/w calcium silicate increased the deliquescent point by...
I was introduced to the Octet Rule recently and make me wonder, why does 8 valence electrons or a full p orbital always make an element inert? What is so special with a full p orbital? Like take Calcium for an example, its outer orbital is filled but its only the s orbital thats filled so its still reactive not so much as the Alkaline metals but still pretty reactive. Can someone explain it to me? Thanks!!
I'm trying to find a cheap DIY method to etch holes of various shapes through 0.3mm Aluminium sheet using 5-10% Sodium Hydroxide. The idea is to apply a resist to the Aluminium then selectively ablate it off using a diode laser cutter and then dissolve away the Aluminium using Sodium Hydroxide. By cheap I mean resists costing say £20 in small quantities. The Internet has suggested various resists to try including... Enamel paint (only survived seconds in the NaOH!) Acrylic paint (only...
Back
Top