Acceleration of Hot Air Balloon

AI Thread Summary
A hot air balloon experiences two forces: an upward lift force and its weight due to gravity, initially accelerating at -g/3. The upward lift force is calculated to be (2g/3)M, where M is the mass of the balloon. To achieve an acceleration of g/2 while maintaining the same lift force, a fraction of the weight must be dropped. The calculations reveal that 5/9 of the total mass must be discarded to achieve the desired acceleration. The discrepancy in the initial calculations stems from misunderstanding the forces acting on the balloon during acceleration.
armolinasf
Messages
195
Reaction score
0

Homework Statement



A hot air balloon of mass M has two forces acting on it. An upward lift force and its weight due to gravity. The balloon is initially accelerating at a rate of -g/3.

A)Find the upward lift force in terms of the initial weight Mg.

B) What fraction of the total weight must be dropped so that he accelerates at a rate of g/2, assume that the upward lifting force remains the same as in part A.


The Attempt at a Solution



F1=Ma=upward lifting force, f2=-Mg=weight

A) I figured that F1/M + F2/M = -g/3

a-g=-g/3
a=2g/3

So then the upward lifting force would be F1=(2g/3)M

B) This time F1/M + F2/M = g/2, but this time F2=-Mgk, k=the fraction of weight that must be dropped

2g/3 - gk = g/2, g will cancel

-3k=-1/2 ==> k=1/6

However, the answer in my book gives 5/9. Where am I going wrong. Thanks!
 
Physics news on Phys.org
You have scored the 1,

But in the 2 )
the baloon is accelerating, that means a force is acting in him. It's accelerating by a acceleration of g/2, so the force is mg/2

the lift force is the same , so it s 2Mg/3, no mg/2, the first M is the initial mass

mg/2 = 2Mg/3 - m g -> m =4/9 M, so 5/9 of the mass was destroyed
 
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
Back
Top