Analog Electronics: Emitter Follower Working Principle

AI Thread Summary
An emitter follower, also known as a common collector amplifier, is a transistor configuration where the output is taken from the emitter. This setup provides high input impedance and low output impedance, making it ideal for buffering signals. The working principle involves the transistor being biased in the active region, allowing it to follow the input voltage while providing current gain. Circuit diagrams typically illustrate the NPN or PNP transistor arrangement with the emitter connected to the output load. Understanding the emitter follower's function and applications is essential for effective analog electronics design.
kuchun
Messages
11
Reaction score
1
What is an emitter follower? I want to know its working principle with proper circuit diagram..
 
Engineering news on Phys.org
kuchun said:
What is an emitter follower? I want to know its working principle with proper circuit diagram..

As in your other thread, Google and wikipedia are your friends:

http://en.wikipedia.org/wiki/Emitter_follower

.
 
Here is a good place that will be helpful I hope

The common collector amplifier, often called an emitter follower since its output is taken from the emitter resistor...

http://hyperphysics.phy-astr.gsu.edu/hbase/electronic/npncc.html"

npncc2.gif


And some good applications.

http://hyperphysics.phy-astr.gsu.edu/hbase/electronic/emitfol.html"
 
Last edited by a moderator:
Berkeman. You're too fast in posting. :smile:
 
dlgoff said:
Here is a good place that will be helpful I hope



http://hyperphysics.phy-astr.gsu.edu/hbase/electronic/npncc.html"

npncc2.gif


And some good applications.

http://hyperphysics.phy-astr.gsu.edu/hbase/electronic/emitfol.html"
Thanx, it was a great link...
 
Last edited by a moderator:
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
Back
Top