Can Ansys Workbench Improve CZM Method for Material Fracture Analysis?

Beulah21
Messages
3
Reaction score
0
TL;DR Summary
EPOXY RESIN WITH CZM
Hello all.
I am new to this platform. Please can anyone kindly put me through? I am modeling slip behavior between FRP and brick masonry. I have an epoxy resin adhesive as the interface. I used CZM method with pure penalty. My questions are as below:
1. Do I model the epoxy adhesive interface as 1 layer or two layers? or how many CZM layers am I expected to have?
2 I am using separation distance-based debonding. do I drag this into epoxy resin? and what values do i use ?
image 2.JPG
 
Engineering news on Phys.org
Thread 'Where is my curb stop?'

Thread 'Where is my curb stop?'

My water meter is submerged under water for about 95% of the year. Today I took a photograph of the inside of my water meter box because today is one of the rare days that my water meter is not submerged in water. Here is the photograph that I took of my water meter with the cover on: Here is a photograph I took of my water meter with the cover off: I edited the photograph to draw a red circle around a knob on my water meter. Is that knob that I drew a red circle around my meter...
View full post »

Thread 'Questions about the Tesla turbine'

Hi all, i have some questions about the tesla turbine: is a tesla turbine more efficient than a steam engine or a stirling engine ? about the discs of the tesla turbine warping because of the high speed rotations; does running the engine on a lower speed solve that or will the discs warp anyway after time ? what is the difference in efficiency between the tesla turbine running at high speed and running it at a lower speed ( as fast as possible but low enough to not warp de discs) and: i...
View full post »

Similar threads

"ANSYS Workbench" Contact tool results plotting vs length?
Replies
1
Views
3K
Ansys workbench Composite Analysis
Replies
22
Views
12K
Ansys - diffrence between ansys multiphysic and WorkBench?
Replies
3
Views
5K
Contact strength in ANSYS Workbench
Replies
2
Views
4K
How Can I Resolve the General Error Message in Ansys Workbench?
Replies
1
Views
4K
Ansys Workbench Help (creating load in center of body)
Replies
3
Views
15K
Plot the contact pressure vs axe x (mm) in ansys workbench
Replies
3
Views
4K
Exploring ANSYS WORKBENCH and APDL: A Scientist's Perspective
Replies
1
Views
403
Multibody Parts in Ansys Workbench
Replies
1
Views
2K
Importing Mechanical Apdl geometry in Ansys Workbench
Replies
5
Views
5K

Hot Threads

Recent Insights

Back
Top