Antenna Theory: What is an Effective Aperture?

  • Thread starter Thread starter JamesC26
  • Start date Start date
  • Tags Tags
    Antenna Theory
AI Thread Summary
The effective aperture of an antenna refers to the measure of how much power the antenna can capture from an incoming plane wave. It is a crucial parameter in antenna theory, indicating the efficiency of an antenna in receiving signals. The effective aperture is typically expressed in square meters and is related to the antenna's gain and the wavelength of the signal. Understanding this concept is essential for optimizing antenna design and performance in various applications. Clarification on this topic can enhance comprehension of antenna functionality in practical scenarios.
JamesC26
Messages
1
Reaction score
0
Hi folks,

Currently working on a project at university, and I have a question on antenna theory.

When talking about the "effective aperture" of an antenna, what exactly is this ?

I have found this explanation but I can't quite get my head round it...
"effective aperture parameter describes how much power is captured from a given plane wave"

Could someone please explain.

Thanks,
James
 
Engineering news on Phys.org

Thread 'How might electronics be different if AC voltage was 72V at 45 Hz?'

Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
View full post »

Thread 'What happens if shielded cable has a short to the shield?'

While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
View full post »

Thread 'Why does the amperage go real high if there is a low voltage short?'

I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
View full post »

Similar threads

Difference between DC/AC coupling (Antennas)
Replies
9
Views
2K
Engineering Link Budget Antenna: use of effective aperture and the gain in a problem
Replies
3
Views
2K
Antenna (Dipole) balun - what is it for?
Replies
14
Views
7K
Linear polarized microstrip patch antenna - design help
Replies
4
Views
2K
A Diffraction theory, power density and angle of incidence
Replies
5
Views
3K
Is this how a dipole antenna works?
Replies
4
Views
3K
Antenna as a source of electricity
Replies
2
Views
2K
Microstrip Antenna: What is Low Profile?
Replies
1
Views
2K
Is the effective aperture of an antenna a constant?
Replies
1
Views
2K
An Explanation of the Effective Area of Isotropic Antenna
Replies
1
Views
4K

Hot Threads

Recent Insights

Back
Top