Automatic Light Dimmer: Experiment at Home w/ 10 120VAC Bulbs

  • Thread starter Thread starter reinaldo
  • Start date Start date
  • Tags Tags
    Automatic Light
AI Thread Summary
An individual is seeking assistance to create an automatic light dimmer for ten 120VAC bulbs that adjusts based on ambient light. They have a schematic from a book but cannot proceed due to the unavailability of a specific component, the X9503 digital potentiometer, in Venezuela. The local trade restrictions complicate online purchases, requiring a lengthy bureaucratic process. The user is looking for alternative schematics that do not require this component. Assistance in finding a workable solution or schematic is requested.
reinaldo
Messages
33
Reaction score
0
Hey everybody!...i want to do an experiment at my house!, i want to do an Automatic Light Dimmer!...that regulates itself with the ambient light, i want to automatize ten(10) 120VAC light bulbs!...the circuit that i have, i got i from "Home Remote Control & Automation Projects" by Delton Horn but i Cant do it because it uses a X9503 digital potenciometer!...the problem is that here in venezuela they don't sell it!...so does anyone has a Schematic that could pass me??...i haven't been able to find a circuit over internet...thanks a lot!
 
Engineering news on Phys.org
I know nothing about electronics. Since you have internet, though, have you tried to purchase the required component on-line?
 
I can't buy it over internet cause our MF commie president in venezuela has got the country under a trade Control!...to buy stuff over the internet you got to do a super long Burocratic process that will take me several months...

i have that schematic but miss the component...and over the internet i can't find an Automatic light Dimmer...that varies the light intensity inversly proportional to the ambient light...does anyone has an schematic that could pass me please!...thanks a lot!...
 
Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...

Similar threads

Replies
12
Views
3K
Replies
12
Views
21K
Replies
31
Views
62K
Replies
30
Views
5K
Replies
1
Views
3K
Replies
2
Views
4K
Back
Top