Basic IR Spectroscopy and dipole moments

AI Thread Summary
A bond stretch or vibration must cause a change in dipole moment to be infrared (IR) active. While all vibrational modes require energy absorption, only those that alter the dipole moment are detected in the IR region of the electromagnetic spectrum. Vibrations that do not change the dipole moment will not be observed in the IR spectrum; instead, they may be detected in the Raman spectrum if they affect the polarization of the molecule. The discussion emphasizes the importance of dipole moment changes for IR activity and clarifies the distinction between IR absorption and Raman emission spectra, noting that Raman spectra can also occur in the IR energy range.
Moogie
Messages
167
Reaction score
1
Hi

Why does a bond stretch or vibration have to cause a change in dipole moment to be IR active?

Presumably all vibrational modes depend on energy aborption to occur whether they cause a change in dipole or not. I'm presuming that only those vibrational modes that cause a dipole change are in the IR region of the EMR spectrum. Other vibrations absorb energy in some other region of the EMR. Is this correct?

Actually as i was typing this I've just read that the reason why vibrations that cause a change in dipole lead to absorptions in the IR region is due to the mechanism by which the photon transfers its energy to the molecule, which is outside the scope of the article i saw.

Can anyone offer a simple explanation to this?

Kind regards
 
Chemistry news on Phys.org
Hi

That's a too involved for my needs but thank-you for your trouble.

Does an IR active vibrational mode have to cause a dipole moment or cause a change in dipole moment? For example if the molecular already had a dipole and a particular vibration occurred but this did not change the dipole would this be IR active, or would the vibration only be IR active if it changed the existing dipole

many thanks
 
Moogie said:
For example if the molecular already had a dipole and a particular vibration occurred but this did not change the dipole would this be IR active, or would the vibration only be IR active if it changed the existing dipole
Typically, IR active modes are only those associated with a changing dipole moment.
 
Moogie said:
Hi
Does an IR active vibrational mode have to cause a dipole moment or cause a change in dipole moment? For example if the molecular already had a dipole and a particular vibration occurred but this did not change the dipole would this be IR active, or would the vibration only be IR active if it changed the existing dipole

If the vibrational mode doesn't involve a change in dipole moment it will not be observed in the infrared spectrum. If that vibration causes a change in the polarization of the molecule (the electron distribution) then it should be observed in the Raman spectrum.
 
cameronforde said:
If the vibrational mode doesn't involve a change in dipole moment it will not be observed in the infrared spectrum. If that vibration causes a change in the polarization of the molecule (the electron distribution) then it should be observed in the Raman spectrum.

Just a quick clarification for the benefit of the readers: Infrared absorption spectrum and Raman emission spectrum, respectively.
The observed Raman spectrum can of course be in the IR energy range.
 
I want to test a humidity sensor with one or more saturated salt solutions. The table salt that I have on hand contains one of two anticaking agents, calcium silicate or sodium aluminosilicate. Will the presence of either of these additives (or iodine for that matter) significantly affect the equilibrium humidity? I searched and all the how-to-do-it guides did not address this question. One research paper I found reported that at 1.5% w/w calcium silicate increased the deliquescent point by...
Back
Top