Block on a rough plane Coefficient of Kinetic Friction

AI Thread Summary
A 3kg block sliding down a rough plane inclined at 27 degrees experiences an acceleration of 2.5 m/s², prompting the calculation of the coefficient of kinetic friction. The net force equation is established as Force Net = M x A, with forces analyzed in both the x and y directions. The frictional force (Fk) is expressed in terms of the coefficient of kinetic friction (mu-k) and gravitational components. The calculations lead to the equation 1.949 = mu-k x 26.196, suggesting a coefficient of kinetic friction of approximately 0.074. Clarifications indicate that mass should cancel out, ensuring the setup of the equations is accurate.
boognish
Messages
15
Reaction score
0
1. A 3kg block slides down a rough plane inclined at an angle of 27 degrees. If the acceleration of the block is 2.5 m/s/s find the coefficient of kinetic friction.



2. solving for components
Force Net = M x A
forces in the y direction: Fn - Fg cos 27 degrees = 0
forces in the x direction: M x G sin 27 degrees - Fk = M x A
Fk = coef-k x m x g cos 27 degrees




3. isolating Fk resolves to:
9.8 sin 27 degrees - 2.5 m/s = Fk
substituting for fk to resolve for coef of kinetic friction resolves to this:
9.8 sin 27 degrees - 2.5 m/s = mu-k x 3 kg x 9.8 cos 27 degrees
1.949 = mu-k x 26.196
mu-k = .074
 
Physics news on Phys.org
is this correct..? I am wondering if all the masses should cancel out in this equation or if I have it set up correctly
 
Your work is section 2 is fine.

9.8 sin 27 degrees - 2.5 m/s = Fk
You've divided the left-hand side by m, but not the right-hand side.
 
Thread 'Variable mass system : water sprayed into a moving container'
Starting with the mass considerations #m(t)# is mass of water #M_{c}# mass of container and #M(t)# mass of total system $$M(t) = M_{C} + m(t)$$ $$\Rightarrow \frac{dM(t)}{dt} = \frac{dm(t)}{dt}$$ $$P_i = Mv + u \, dm$$ $$P_f = (M + dm)(v + dv)$$ $$\Delta P = M \, dv + (v - u) \, dm$$ $$F = \frac{dP}{dt} = M \frac{dv}{dt} + (v - u) \frac{dm}{dt}$$ $$F = u \frac{dm}{dt} = \rho A u^2$$ from conservation of momentum , the cannon recoils with the same force which it applies. $$\quad \frac{dm}{dt}...
Back
Top