Calculating Flowerpot Height | Freefall Problem Help

  • Thread starter Thread starter teknodude
  • Start date Start date
  • Tags Tags
    Freefall
AI Thread Summary
The discussion revolves around calculating the height a flowerpot reaches above a window after being observed for 0.61 seconds, with the window height being 2.45 meters. Initial calculations suggested an initial velocity of 7.00 m/s, but confusion arose regarding the total time in view, which should be halved for accurate calculations. After realizing the mistake, the correct approach led to a height of 2.45 meters for the textbook problem, confirming that the initial calculations were flawed. Participants emphasized the importance of correctly interpreting the time variable in projectile motion problems. The conversation highlights the need for careful analysis in physics problems to avoid errors.
teknodude
Messages
150
Reaction score
0
A drowsy cat spots a flowerpot that sails first up and then down past an open window. The pot was in view for a total of 0.61 seconds, and the top-to-bottom height of the window is 2.45 meters. How high above the window top did the flowerpot go?

I first tried to calculate the initial velocity by assuming the initial position to be zero and the 2.45 for the max. Using formula y=-1/2gt^2 + v(t) +Yinitial
2.45 = -1/2g(0.61)^2 + V(0.61) o
intial velocity=7.00 m/s

velocity should equal zero, that's when the flowerpot reached its highest point. Then solving for time when the pots velocity is zero, will be give enough info to calculate the height above the window the pot traveled. Using equation v=-gt+vintial 0= -gt + 7.00 t= 0.714s

Plugging back into the first used equation
y= -4.9(0.714)^2 +7.00(0.714) y= 2.50m subtracting from 2.45m = 0.049m

So the flowerpot went 0.049m above the window?

I enter my homework answers on this site called webassign. My first answer was incorrect and another wrong answer will start deducting points...

I am really confused because my textbook had the same Homework problem, however the values were different. height was 2.00m, time= 0.50s. I did the same procedure as stated above on the problem in my text, but i could Not get close to the answer of 2.34m from the solution in the back of the book.
 
Last edited:
Physics news on Phys.org
Welcome to PF!
teknodude said:
A drowsy cat spots a flowerpot that sails first up and then down past an open window. The pot was in view for a total of 0.61 seconds, and the top-to-bottom height of the window is 2.45 meters. How high above the window top did the flowerpot go?
Note that it gives total time in view. Each pass is only half that time.

I first tried to calculate the initial velocity by assuming the initial position to be zero and the 2.45 for the max. Using formula y=-1/2gt^2 + v(t) +Yinitial
2.45 = -1/2g(0.61)^2 + V(0.61) o
intial velocity=7.00 m/s
Nothing wrong with your thinking, but you have the wrong time. Do it over.
I am really confused because my textbook had the same Homework problem, however the values were different. height was 2.00m, time= 0.50s. I did the same procedure as stated above on the problem in my text, but i could Not get close to the answer of 2.34m from the solution in the back of the book.
The book's answer is correct. So you know that you are doing something wrong! Probably the same error. Redo the textbook problem and make sure you get it right before redoing your homework.
 
Thanks Doc Al, I overlooked the fact that the time given was total time. I redid the problem in the textbook and got 2.45m as my answer. :biggrin:
 
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
Thread 'Variable mass system : water sprayed into a moving container'
Starting with the mass considerations #m(t)# is mass of water #M_{c}# mass of container and #M(t)# mass of total system $$M(t) = M_{C} + m(t)$$ $$\Rightarrow \frac{dM(t)}{dt} = \frac{dm(t)}{dt}$$ $$P_i = Mv + u \, dm$$ $$P_f = (M + dm)(v + dv)$$ $$\Delta P = M \, dv + (v - u) \, dm$$ $$F = \frac{dP}{dt} = M \frac{dv}{dt} + (v - u) \frac{dm}{dt}$$ $$F = u \frac{dm}{dt} = \rho A u^2$$ from conservation of momentum , the cannon recoils with the same force which it applies. $$\quad \frac{dm}{dt}...
Back
Top