Calculating Forces: 1kg & 0.5kg Carts

  • Thread starter Thread starter UrbanXrisis
  • Start date Start date
  • Tags Tags
    Carts Forces
AI Thread Summary
The discussion focuses on calculating the forces acting on a 1kg cart and a 0.5kg cart connected together with an applied force of 4N on the 1kg cart. The calculations show that the force on the 1kg cart due to the 0.5kg cart is 1.3N, while the force on the 0.5kg cart due to the 1kg cart is 2.67N. This distribution of force is explained by the different masses of the carts, with the larger mass experiencing a greater force. The calculations are confirmed to be correct by participants in the discussion. Overall, the analysis effectively applies Newton's second law to the scenario.
UrbanXrisis
Messages
1,192
Reaction score
1
There is a1kg cart with a 0.5kg cart attached to it. There is an applied force of 4N on the 1kg cart:

--4N-->[1kg][0.5kg]

What is the force on the 1kg cart due to the 0.5 kg cart?
F=ma
4N=1.5a
a=2.67m/s^2

F=ma
F=(0.5)(2.67m/s^2)
F=1.3

What is the force on the 0.5kg cart due to the 1 kg cart?
F=ma
F=(1)(2.67m/s^2)
F=2.67N

is this correct?
 
Physics news on Phys.org
Looks good to me.
 


Yes, your calculations are correct. The force on the 1kg cart due to the 0.5kg cart is 1.3N, and the force on the 0.5kg cart due to the 1kg cart is 2.67N. This is because the force applied on the 1kg cart is distributed between the two carts, with the larger cart experiencing a greater force due to its larger mass.
 
Thread 'Minimum mass of a block'
Here we know that if block B is going to move up or just be at the verge of moving up ##Mg \sin \theta ## will act downwards and maximum static friction will act downwards ## \mu Mg \cos \theta ## Now what im confused by is how will we know " how quickly" block B reaches its maximum static friction value without any numbers, the suggested solution says that when block A is at its maximum extension, then block B will start to move up but with a certain set of values couldn't block A reach...
TL;DR Summary: Find Electric field due to charges between 2 parallel infinite planes using Gauss law at any point Here's the diagram. We have a uniform p (rho) density of charges between 2 infinite planes in the cartesian coordinates system. I used a cube of thickness a that spans from z=-a/2 to z=a/2 as a Gaussian surface, each side of the cube has area A. I know that the field depends only on z since there is translational invariance in x and y directions because the planes are...
Thread 'Calculation of Tensile Forces in Piston-Type Water-Lifting Devices at Elevated Locations'
Figure 1 Overall Structure Diagram Figure 2: Top view of the piston when it is cylindrical A circular opening is created at a height of 5 meters above the water surface. Inside this opening is a sleeve-type piston with a cross-sectional area of 1 square meter. The piston is pulled to the right at a constant speed. The pulling force is(Figure 2): F = ρshg = 1000 × 1 × 5 × 10 = 50,000 N. Figure 3: Modifying the structure to incorporate a fixed internal piston When I modify the piston...
Back
Top