Calculating Work Done by a Force on a Coin

AI Thread Summary
A coin moves across a frictionless plane from the origin to the coordinates (2.2 m, 6.1 m) under the influence of an 8.2 N force at a 108° angle from the x-axis. The displacement is calculated using the distance formula, resulting in approximately 6.48 m. The angle between the force and displacement is determined to be 38° after finding the angle of displacement as 70.167°. The work done by the force is then calculated using the formula W = FdCos(a), yielding a result of 42 Joules. This confirms the correct approach to solving the problem.
dorkymichelle
Messages
40
Reaction score
0

Homework Statement


A coin slides over a frictionless plane and across an xy coordinate system from the origin to a point with xy coordinates (2.2 m, 6.1 m) while a constant force acts on it. The force has magnitude 8.2 N and is directed at a counterclockwise angle of 108° from the positive direction of the x axis. How much work is done by the force on the coin during the displacement?

Homework Equations


W=FdCos a
a = angle between force and displacement
x2+y2 = d2

The Attempt at a Solution



pt 1 = 0,0, pt 2 = 2.2m, 6.1m
using distance formula
displacement = square root (2.2)2+6.12
d= 6.48
force = 8.2
and a = 108 degrees
so w = 8.2*6.48 *cos 108 = -16.42 J
I think the problem is that the angle between displacement and force is not really 108 and I am supposed to figure out where it is.. not I'm not sure where that's going..

edit , I just did tan b = 6.1/2.2
b = 70.167 degrees, being the angle between the displacement and pos x axis.
would the angle a, between force and displacement be angle of force - angle of displacement? 108-70 = 38 degrees.
and 38 degrees would be the angle that is put into the w = f*d equation?
I need someone to confirm because I'm on my last try on homework = /
 
Physics news on Phys.org
yup. looks good. I'll do it quick here to make sure we both get the same answer. One sec..

I get 42 Joules (to 2 sig figs)
 
I multiplied the values first without the error limit. Got 19.38. rounded it off to 2 significant figures since the given data has 2 significant figures. So = 19. For error I used the above formula. It comes out about 1.48. Now my question is. Should I write the answer as 19±1.5 (rounding 1.48 to 2 significant figures) OR should I write it as 19±1. So in short, should the error have same number of significant figures as the mean value or should it have the same number of decimal places as...
Thread 'A cylinder connected to a hanging mass'
Let's declare that for the cylinder, mass = M = 10 kg Radius = R = 4 m For the wall and the floor, Friction coeff = ##\mu## = 0.5 For the hanging mass, mass = m = 11 kg First, we divide the force according to their respective plane (x and y thing, correct me if I'm wrong) and according to which, cylinder or the hanging mass, they're working on. Force on the hanging mass $$mg - T = ma$$ Force(Cylinder) on y $$N_f + f_w - Mg = 0$$ Force(Cylinder) on x $$T + f_f - N_w = Ma$$ There's also...
Back
Top