Charge flow through a mains tester

AI Thread Summary
The discussion centers on how a screwdriver tester indicates live mains power by completing a circuit through the human body. When the tester's pointed end contacts the mains, the circuit is completed as the charge flows from the 'phase' pin to the body and back through the neutral, which is grounded. It is clarified that in residential wiring, neutral and earth are connected at the breaker box, allowing for this low-current flow. Additionally, non-contact voltage detectors can sense AC voltage without a direct return path by detecting the electromagnetic field radiating from the wiring. The explanation concludes that the flow of charge in this scenario is indeed correct, demonstrating the interconnectedness of neutral and ground in electrical systems.
akhil123
Messages
14
Reaction score
0
We often use screw driver testers, where we touch one end of the screw driver with our finger and put the pointed end into the mains. The bulb inside the tester glows, indicating that the mains are active.
My question is, how is the circuit completed in this case? If charge flows from our body to ground, how does it go back to the 'source', which is the other pin of the mains power supply?
 
Engineering news on Phys.org
The "other pin of the mains" is at ground potential. So you have a path; for very low current in this case.
 
Does that mean that both the neutral and Earth pin are shorted i.e. connected to the ground?
 
Residential wiring in the US requires a safety ground alone with the neutral which are both attached to ground at the breaker box.
 
I've got one of these in my tool bag (a non-contact voltage detector):
http://www.mygreenlee.com/GreenleeD...=showGreenleeProductTemplate&upc_number=09022

It's able to pick up the 'hot' leg of household AC without a return path or even any (significant) current flowing through the wire. May seem magical (and may have literally been a life-saver once or twice) but it just picks up the 50/60 Hz radiating off the cabling. There's a more expensive model which allows you to adjust the sensitivity and trace live wiring inside of walls / ceilings, but tone and probe kits work a little better for that (the toner injects a stronger and higher frequency signal that's more easily detected by the probe--but it's still the same basic principle)
 
That means in the case of a charger, charges flow from the 'phase' pin of the socket to human body and then from the common ground to the neutral part of the socket, since neutral and earthing are connected. Is this explanation correct?
 
I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
Thread 'How Does Jaguar's 1980s V12 Dual Coil Ignition System Enhance Spark Strength?'
I have come across a dual coil ignition system as used by Jaguar on their V12 in the 1980's. It uses two ignition coils with their primary windings wired in parallel. The primary coil has its secondary winding wired to the distributor and then to the spark plugs as is standard practice. However, the auxiliary coil has it secondary winding output sealed off. The purpose of the system was to provide a stronger spark to the plugs, always a difficult task with the very short dwell time of a...
Back
Top