Design Astable Circuit with Op Amp | Control TH, TL, VH & VL

Thread starter mfecky
Start date May 21, 2011
Tags

Circuit Design

AI Thread Summary

The discussion focuses on designing an astable circuit using an operational amplifier (op-amp) while controlling the variables TH (time high), TL (time low), VH (high output voltage), and VL (low output voltage). Participants seek clarification on the definitions and roles of these variables in the circuit design. The use of simulation software like Multisim is suggested for testing and visualizing the circuit's behavior. The goal is to achieve precise control over the output voltages and timing intervals. Assistance is requested to better understand how to implement these controls in the astable circuit design.

May 21, 2011

mfecky

Hi every one, i want to design astable circuit using op_amp and i want control TH ,TL,VH and VL

for example VH=x ,VL=y (x,y ara variables which i can cotrol them )
TH=m , Tl =n (m , n ara variables which i can cotrol them )

using multisim or any simulation program

Engineering news on Phys.org

May 21, 2011

KingNothing

What are TH, TL, VH and VL?

May 21, 2011

mfecky

VH ,VL(high,low output voltage)

TH,TL (time charging and discharging)

May 21, 2011

mfecky

i will be grateful if u help me

Thread '3-terminal device external modeling'

Very basic question. Consider a 3-terminal device with terminals say A,B,C. Kirchhoff Current Law (KCL) and Kirchhoff Voltage Law (KVL) establish two relationships between the 3 currents entering the terminals and the 3 terminal's voltage pairs respectively. So we have 2 equations in 6 unknowns. To proceed further we need two more (independent) equations in order to solve the circuit the 3-terminal device is connected to (basically one treats such a device as an unbalanced two-port...

View full post »

Thread 'Question about the voltage between two charged capacitors'

suppose you have two capacitors with a 0.1 Farad value and 12 VDC rating. label these as A and B. label the terminals of each as 1 and 2. you also have a voltmeter with a 40 volt linear range for DC. you also have a 9 volt DC power supply fed by mains. you charge each capacitor to 9 volts with terminal 1 being - (negative) and terminal 2 being + (positive). you connect the voltmeter to terminal A2 and to terminal B1. does it read any voltage? can - of one capacitor discharge + of the...

View full post »

Thread 'Weird near-field phenomenon I get in my EM simulation'

I recently made a basic simulation of wire antennas and I am not sure if the near field in my simulation is modeled correctly. One of the things that worry me is the fact that sometimes I see in my simulation "movements" in the near field that seems to be faster than the speed of wave propagation I defined (the speed of light in the simulation). Specifically I see "nodes" of low amplitude in the E field that are quickly "emitted" from the antenna and then slow down as they approach the far...

View full post »