Did I Solve the Vertical Post Problem Correctly Using SOH CAH TOA?

AI Thread Summary
The discussion centers on solving the vertical post problem using trigonometric principles, specifically SOH CAH TOA. The user initially calculated an angle of 33 degrees for Theta but was corrected, as the vertical components of the tension in the cables do not need to be equal. Instead, the correct angle, as confirmed by calculations, is 63 degrees, derived from balancing the horizontal components of the tensions. The explanation clarifies that the vertical post remains upright due to the balance of forces, with the tension in the cables providing stability. Understanding these principles is crucial for accurately solving similar physics problems.
Ryan Lau
Messages
13
Reaction score
0

Homework Statement


A vertical post is held in place by two cables as shown.

Homework Equations


SOH CAH TOA

The Attempt at a Solution


http://postimg.org/image/6rgssb1j5/

The answer in the textbook is 63 degrees. Is this an issue or did I do something terribly wrong?
 
Physics news on Phys.org
The tension in the cables keep the post in vertical position. Its top point can not move sideways, the horizontal components of the tensions balance each other.
The vertical components do not need to be equal, as they are balanced by the force from the ground.
 
ehild said:
The tension in the cables keep the post in vertical position. Its top point can not move sideways, the horizontal components of the tensions balance each other.
The vertical components do not need to be equal, as they are balanced by the force from the ground.
Unfortunately, I do not fully comprehend this explanation. My question is why 33 degrees is not the correct angle for Theta.
 
Ryan Lau said:
Unfortunately, I do not fully comprehend this explanation. My question is why 33 degrees is not the correct angle for Theta.
You calculated theta from the condition that the vertical components of the tensions are equal, which is wrong .
 
ehild said:
You calculated theta from the condition that the vertical components of the tensions are equal, which is wrong .

I believe I understand this comment now.

Overview:
To keep the vertical post upright, both the left and right side of the ground by the tensional strings will be equal to each other.

1500cos50 = 964.1814 N = Adjacent Side (floor)
Cos Inv. (964.1814/2100) = 62.6688 N (angle required to keep the pole upright)
 
And the rounded value is 63°.
 
Thread 'Variable mass system : water sprayed into a moving container'
Starting with the mass considerations #m(t)# is mass of water #M_{c}# mass of container and #M(t)# mass of total system $$M(t) = M_{C} + m(t)$$ $$\Rightarrow \frac{dM(t)}{dt} = \frac{dm(t)}{dt}$$ $$P_i = Mv + u \, dm$$ $$P_f = (M + dm)(v + dv)$$ $$\Delta P = M \, dv + (v - u) \, dm$$ $$F = \frac{dP}{dt} = M \frac{dv}{dt} + (v - u) \frac{dm}{dt}$$ $$F = u \frac{dm}{dt} = \rho A u^2$$ from conservation of momentum , the cannon recoils with the same force which it applies. $$\quad \frac{dm}{dt}...
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
Back
Top