Difficulty - Signals and Systems

AI Thread Summary
A characteristic mode in a system refers to its natural oscillation pattern, which allows the system to sustain signals that match this frequency without external interference. When energy is added at a frequency that aligns with the system's characteristic mode, it can be continuously absorbed, enhancing the system's response, as illustrated by the swing analogy. Conversely, energy added at non-matching frequencies will not be effectively utilized, leading to minimal progress. The discussion also touches on the impact of energy dissipators, suggesting that the term "sustained" may not apply in those contexts. Overall, understanding characteristic modes is crucial for effective energy transfer in systems.
salil87
Messages
26
Reaction score
0
Hi
In my notes I came across the following sentences:-
Any signal consisting of the system's characteristic mode is sustained by the system on its own. The system offers no obstacle to this signal.
Not getting what it means. Please, a little help needed. :-)

Thanks
salil
 
Engineering news on Phys.org
A characteristic mode is simply a natural oscillation pattern the system possesses. If you add energy to a system which is NOT in one of the system's natural oscillation patterns, then that energy will not be continually absorbed over time. For example, if you are pushing someone on a swing and the frequency you are pushing does not match the natural frequency of the swing, then you won't make any notable progress getting the swing going. But if you add energy at the 'characteristic mode' of the swing (the right spectrum of frequencies), then it will be continually absorbed causing the swing amplitude to increase. If there is an energy waster (like an electrical resistor, brake, wind resistance, etc.) in the system then I'm not sure I'd use the word "sustained" as they do in the statement, but I think the general point is that that energy will be absorbed by the system.
 
I have no idea what that is supposed to mean, out of context. Can you give a longer quote? Is the quote a computer translation from a different language?

Fleem's answer might be correct, or it might not.
 
Sorry for the short Description. Guess it happens when I'm in tension. :-) But Thanks a lot Fleem ... your explanation helped a lot. Your Swing example rocks. Sometimes I think of such simple things in such complicated ways. Thanks a lot again. :-)
Thanks
Salil
 
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
Back
Top