Discovering the Truth: My Encounter with a Micro Robot Inside My Body

  • Thread starter Thread starter realneed
  • Start date Start date
  • Tags Tags
    Body Micro Robot
AI Thread Summary
A user reports experiencing pain and irritation from a suspected micro robot implanted in their body, expressing concern over its mobility and the challenges of detecting it with standard imaging techniques like MRI and X-ray. They inquire about the possibility of disrupting the device's control signal and seek information on research and development in autonomous micro robotics. Suggestions include blocking the signal with materials like tinfoil, although some participants note that robotic brain implants are outside the forum's focus. The discussion emphasizes the importance of seeking medical assistance for such issues. Overall, the user is looking for practical solutions and credible information regarding their situation.
realneed
Messages
1
Reaction score
0
Some one has put a devise in me and you clever people of the world may be my only saviour.
It must have cost a fair bit because it can move around,inflict pain and irritations to say the least.
The point is,if its metal, Mri scan is out. X ray,ive tried no show(it moves) Would trying to take over the transmitting frequency be possible.
Would anyone know where to get info on R & D that's been ongoing in the field of autonomous micro robotics.
This is a real question from a real person and a very very realneed
 
Engineering news on Phys.org
You can de-activate the robot by blocking it's reception of the control signal. Devices such as these are almost always controlled from government satelites, radio towers, or extraterrestrial signals. These can eaisly be blocked by wearing tinfoil on the head.
 
realneed, I'm afraid that robotic brain implants are beyond the scope of what we deal with here. I suggest you continue to seek medical help.
 

Thread 'Race car suspension Class'

Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
View full post »

Thread 'Cantilever help'

I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
View full post »
Thread 'What's the most likely cause for this carbon seal crack?'

Thread 'What's the most likely cause for this carbon seal crack?'

We have a molded carbon graphite seal that is used in an inline axial piston, variable displacement hydraulic pump. One of our customers reported that, when using the “A” parts in the past, they only needed to replace them due to normal wear. However, after switching to our parts, the replacement cycle seems to be much shorter due to “broken” or “cracked” failures. This issue was identified after hydraulic fluid leakage was observed. According to their records, the same problem has occurred...
View full post »

Similar threads

Current and Future AI Threats to Humanity and the Human Response
Replies
10
Views
4K
BRS: PKI Cryptosystems for SA/Ms: A Tutorial
Replies
13
Views
3K
Futility of self-pride and indignation
Replies
27
Views
5K

Hot Threads

Recent Insights

Back
Top