Does anyone know how to make rust from steel plates

AI Thread Summary
The discussion centers on the process of creating iron oxide from plate steel using electrolysis, with a focus on safety and efficiency. The user plans to process the steel in small, 2-pound batches within a polyurethane tub and aims to capture the hydrogen gas produced during the process. Suggestions include grinding the steel into granules or powder to expedite the reaction and adding extra oxygen or hydrogen peroxide to enhance efficiency. Safety considerations are emphasized, particularly regarding the use of hydrogen peroxide, and the user is encouraged to verify safety protocols while utilizing available power tools for the task.
eightbitbeast
Messages
4
Reaction score
0
I want to make some iron oxide from plate steel i have a couple hundred pounds that I can process but want to make about 50 pounds id prefer to just do it by electrolysis. Do to safety issues I would prefer to process it in 2 pound batches in a polyurethane tub. I would also like to save the hydrogen gas I am mainly curious if this process is the most efficent or safest.
 
Chemistry news on Phys.org
If you were to grind your steel into granules or powder you would get a result more quickly.
Add additional oxygen if you want to speed things up even more,add some some hydrogen peroxide.
I don't think that would get into danger territory but you might want to check that.
 
  • Like
Likes eightbitbeast
Thank you ill look into that i have plenty of power tools i can use
 
I want to test a humidity sensor with one or more saturated salt solutions. The table salt that I have on hand contains one of two anticaking agents, calcium silicate or sodium aluminosilicate. Will the presence of either of these additives (or iodine for that matter) significantly affect the equilibrium humidity? I searched and all the how-to-do-it guides did not address this question. One research paper I found reported that at 1.5% w/w calcium silicate increased the deliquescent point by...
I was introduced to the Octet Rule recently and make me wonder, why does 8 valence electrons or a full p orbital always make an element inert? What is so special with a full p orbital? Like take Calcium for an example, its outer orbital is filled but its only the s orbital thats filled so its still reactive not so much as the Alkaline metals but still pretty reactive. Can someone explain it to me? Thanks!!
I'm trying to find a cheap DIY method to etch holes of various shapes through 0.3mm Aluminium sheet using 5-10% Sodium Hydroxide. The idea is to apply a resist to the Aluminium then selectively ablate it off using a diode laser cutter and then dissolve away the Aluminium using Sodium Hydroxide. By cheap I mean resists costing say £20 in small quantities. The Internet has suggested various resists to try including... Enamel paint (only survived seconds in the NaOH!) Acrylic paint (only...
Back
Top