Finding the Density of a Duck Floating on a Lake

AI Thread Summary
To find the average density of a duck floating on a lake with 28% of its volume submerged, the relationship between buoyant force and the weight of the duck is crucial. The buoyant force equals the weight of the water displaced, which can be expressed as the density of water multiplied by the submerged volume of the duck. By assuming the total volume of the duck is 1, the submerged volume becomes 0.28, leading to the equation where the weight of the duck equals the buoyant force. This results in the formula for the duck's density being derived from the mass and volume relationship, ultimately confirming that the density of the duck can be calculated using the submerged volume proportion. The discussion emphasizes the importance of maintaining consistent units and algebraic expressions throughout the calculations.
MKM
Messages
16
Reaction score
0
A duck is floating on a lake with 28% of its volume beneath the water. What is the average density of the duck?
This question seems pretty straight froward I realize ultimately that in order to find the answer the duck density= duck mass/duck V. If it is 28% I am assuming that should equal .28V and I know I need to use the formula for bouyant force FB=Weight of fluid=density of fluid x Volume of fluid x g I can plug in the density of fluid but I am not sure how to find all of the other variables having only been given a percentage of the Volume.
 
Last edited:
Physics news on Phys.org
You said that the bouyancy force is equal to the the weight of water displaced. So what is the force oppossing this?

i.e. Can you write the weight of the duck in terms of it's density and volume?

Regards,
Sam
 
I think its W= density .28V x 9.8
 
Lets say the volume of the duck is one(this assumption won't change anything since the density of the duck doesn't depend on its mass, it will sink 28% of its volume no matter what its volume is). then the volume beneath water is 28/100. The mass of the duck times g will be equal to the density of water times 28/100 times g.

M\times{9.8} = d_{w}\times{0.28}\times{9.8}

Now, the volume is \frac{M}{V} = M
 
MKM said:
I think its W= density .28V x 9.8

Almost, its whole mass is going to give it weight, think about your V term.
Tip: Always write algebra until the end, just in case things cancel (especially g). :wink:

So you have:

W=?=Bouyancy=\rho_{watter}V_{water}g

You also know:
V_{water}=0.28V_{duck}

dx said:
Now, the volume is
\frac{M}{V}=M

Surely a typo !??

Regards,
Sam
 
Can you take it from here?
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top