Flexural Wave Propagation speed

AI Thread Summary
The discussion centers on finding the formula for flexural wave propagation speed in beams, specifically addressing whether the inquiry pertains to longitudinal or transverse waves. The original poster is a master's student in mechanical engineering and has some foundational knowledge of wave types. Participants encourage sharing relevant equations and resources to provide better guidance. Clarification on the specific type of wave is deemed necessary for accurate assistance. The conversation emphasizes the importance of foundational knowledge in addressing the problem effectively.
billu
Messages
3
Reaction score
0
Hello Everyone,

my question is that what's the formula or equation to find flexural wave propagation speed along the beam??

Please guide with this, I am kind of stuck in this problem.

Thanks in advance,waiting for the response...
 
Engineering news on Phys.org
billu said:
Hello Everyone,

my question is that what's the formula or equation to find flexural wave propagation speed along the beam??

Please guide with this, I am kind of stuck in this problem.

Thanks in advance,waiting for the response...
I'd mentioned in your introduction thread that you should post links to what you have been reading, so we can judge how best to help you. What level are you in school right now? Are you in university studying Mechanical Engineering?

Are you asking about longitudinal or transverse mechanical waves in the beam?
 
berkeman said:
I'd mentioned in your introduction thread that you should post links to what you have been reading, so we can judge how best to help you. What level are you in school right now? Are you in university studying Mechanical Engineering?

Are you asking about longitudinal or transverse mechanical waves in the beam?
I am masters student in hanyang UNiversity South Korea. Doing engineering,yEa.
 
berkeman said:
Are you asking about longitudinal or transverse mechanical waves in the beam?
And what equations have you learned so far for such waves in solids?
 
I have learned about tranverse waves, longitudinal waves, shear waves.
 
billu said:
I have learned about tranverse waves, longitudinal waves, shear waves.
Good. :smile: Can you then post some of the equations that you asked about in your first post above?
 

Thread 'Race car suspension Class'

Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
View full post »

Thread 'Cantilever help'

I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
View full post »
Thread 'What's the most likely cause for this carbon seal crack?'

Thread 'What's the most likely cause for this carbon seal crack?'

We have a molded carbon graphite seal that is used in an inline axial piston, variable displacement hydraulic pump. One of our customers reported that, when using the “A” parts in the past, they only needed to replace them due to normal wear. However, after switching to our parts, the replacement cycle seems to be much shorter due to “broken” or “cracked” failures. This issue was identified after hydraulic fluid leakage was observed. According to their records, the same problem has occurred...
View full post »

Similar threads

Bending of a telescopic crane boom
Replies
4
Views
3K
Calculating Flexural Wave Propagation Speed Along a Beam
Replies
1
Views
1K
Speed of a sound wave (compressibe flow)
Replies
6
Views
2K
Evanescent waves at change of cross section
Replies
1
Views
2K
Derivation of First Storey Shear Rigidity for a Rigid Frame
Replies
2
Views
1K
How to check a numerical simulation is energy conservative?
Replies
22
Views
3K
Propagation Wave Expressions and Wave Velocity
Replies
9
Views
2K
Honeycomb Structures and Resolution in FEM
Replies
0
Views
1K
I Gravitational wave propagation in GR
Replies
39
Views
3K
I Gravity Wave Speed: Deriving Constancy from Maxwell Eqs.
Replies
34
Views
2K

Hot Threads

Recent Insights

Back
Top