For a damped RLC circuit, why must R be small?

AI Thread Summary
In a damped RLC circuit, a small resistance (R) is crucial for achieving underdamped behavior, which allows for oscillations in the system. The discussion highlights that the differential equation governing the circuit's motion has different solutions based on the damping level, categorized into underdamped, overdamped, and critically damped cases. Only the underdamped case exhibits oscillations due to the presence of complex roots in the characteristic equation, leading to decaying oscillations. In contrast, overdamped and critically damped cases result in purely exponential decay without oscillations. Understanding these damping scenarios is essential for analyzing circuit behavior effectively.
Taulant Sholla
Messages
96
Reaction score
5

Homework Statement


I'm reading the textbook section covering damped series RLC circuits (provided below). I'm wondering why the author stipulates "When R is small..."
Capture.JPG


Homework Equations


Given above.

The Attempt at a Solution


Given above.
Any gentle and courteous comments are welcome!
 

Attachments

  • Capture.JPG
    Capture.JPG
    72.7 KB · Views: 1,109
Physics news on Phys.org
There are three cases for damping in mechanical or electrical systems. What are they?

Hint: The solution of the differential equation describing the motion has different forms depending upon the level of damping.
 
gneill said:
There are three cases for damping in mechanical or electrical systems. What are they?

Hint: The solution of the differential equation describing the motion has different forms depending upon the level of damping.
Ah - very helpful, thank you!
 
Wikipedia has a very good entry (I believe so) in this subject https://en.wikipedia.org/wiki/RLC_circuit#Series_RLC_circuit

Notice the general form of the solution and how it changes in the three cases;
Underdamped, Overdamped, Critically Damped. Oscillations (to be accurate decaying oscillations) happen only in the underdamped case . That's because the characteristic equation has complex roots at this case so the exponentials of the generic solution have an oscillation term ##e^{-j\omega t}##. In the other two cases we just have exponential decay of the current.
 
Last edited:
Thread 'Variable mass system : water sprayed into a moving container'
Starting with the mass considerations #m(t)# is mass of water #M_{c}# mass of container and #M(t)# mass of total system $$M(t) = M_{C} + m(t)$$ $$\Rightarrow \frac{dM(t)}{dt} = \frac{dm(t)}{dt}$$ $$P_i = Mv + u \, dm$$ $$P_f = (M + dm)(v + dv)$$ $$\Delta P = M \, dv + (v - u) \, dm$$ $$F = \frac{dP}{dt} = M \frac{dv}{dt} + (v - u) \frac{dm}{dt}$$ $$F = u \frac{dm}{dt} = \rho A u^2$$ from conservation of momentum , the cannon recoils with the same force which it applies. $$\quad \frac{dm}{dt}...
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...

Similar threads

Back
Top