Friction coefficient of drawer slides

AI Thread Summary
The friction coefficient of drawer slides varies significantly based on the specific slide and the surface it interacts with. A general method to determine this coefficient involves conducting a simple experiment tailored to the specific slide-surface combination. For reference, rolling element bearings typically have a friction coefficient around 0.002. Additionally, linear bearings without rolling elements, such as those using Teflon bushings, exhibit a higher coefficient of friction. Understanding these variations is crucial for applications in robotic mechanisms.
yanikomer
Messages
21
Reaction score
0
Hello everyone

Do you know approximately the friction coefficient in drawer slides? I am going to use it in a robotic mechanism.

Thanks
 
Engineering news on Phys.org
I mean... that's incredibly variable. If you have a specific slide, and you know what surface it will be sliding on, then there is a (semi-)quick little experiment you can do to find the coefficient, but the coefficient is going to be different for every single slide/surface combination.
 
i just want to know if there is somebody who has used these slides and known the coefficient of the friction.
 
You can just say "it must be about..." this is enough for me.
 
Last edited by a moderator:
How did you find PF?: Via Google search Hi, I have a vessel I 3D printed to investigate single bubble rise. The vessel has a 4 mm gap separated by acrylic panels. This is essentially my viewing chamber where I can record the bubble motion. The vessel is open to atmosphere. The bubble generation mechanism is composed of a syringe pump and glass capillary tube (Internal Diameter of 0.45 mm). I connect a 1/4” air line hose from the syringe to the capillary The bubble is formed at the tip...
Thread 'What type of toilet do I have?'
I was enrolled in an online plumbing course at Stratford University. My plumbing textbook lists four types of residential toilets: 1# upflush toilets 2# pressure assisted toilets 3# gravity-fed, rim jet toilets and 4# gravity-fed, siphon-jet toilets. I know my toilet is not an upflush toilet because my toilet is not below the sewage line, and my toilet does not have a grinder and a pump next to it to propel waste upwards. I am about 99% sure that my toilet is not a pressure assisted...
After over 25 years of engineering, designing and analyzing bolted joints, I just learned this little fact. According to ASME B1.2, Gages and Gaging for Unified Inch Screw Threads: "The no-go gage should not pass over more than three complete turns when inserted into the internal thread of the product. " 3 turns seems like way to much. I have some really critical nuts that are of standard geometry (5/8"-11 UNC 3B) and have about 4.5 threads when you account for the chamfers on either...
Back
Top