Full Load & No Load: Meaning in Motor Context

  • Thread starter Thread starter eric336
  • Start date Start date
  • Tags Tags
    Load
AI Thread Summary
In the context of motors, "full load" refers to the maximum mechanical load that the motor can handle, causing it to draw its rated current. Conversely, "no load" indicates the condition when the motor operates without any mechanical load attached to its shaft, resulting in a lower current draw. The no-load current is specifically the current consumed by the motor when it is running without any load. Understanding these terms is crucial for evaluating motor performance and efficiency. Properly distinguishing between full load and no load helps in optimizing motor applications.
eric336
Messages
11
Reaction score
0
What is the meaning of full load and no load, in the context of motor? Does the load here mean mechanical load?
 
Engineering news on Phys.org
In that sense, is it that no-load current means the current in motor when the mechanical load is absent?
 
yes, it means that there is no load attached to the motor shaft
 
and full load means full rated load
 
i think so , the load which causes the armature to draw full rated current
 

Thread 'How might electronics be different if AC voltage was 72V at 45 Hz?'

Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
View full post »

Thread 'Why does the amperage go real high if there is a low voltage short?'

I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
View full post »

Thread 'What happens if shielded cable has a short to the shield?'

While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
View full post »

Similar threads

Electric motor - variable torque vs speed
Replies
13
Views
2K
Generator load sharing
Replies
4
Views
2K
Power factor of motor with VSD?
Replies
1
Views
2K
Variable vs constant power supply
Replies
32
Views
2K
40A MCB will trip, but 63A won't: Is this logic even logical?
Replies
36
Views
4K
How can the output power of a motor be controlled using an inverter?
Replies
6
Views
2K
Mosfet failures in this differential piezo drive circuit
Replies
12
Views
2K
Induction motor windings, number of turns per phase and per pole
Replies
2
Views
4K
If DC current is chopped on it's way to a load, what happens to the EM?
Replies
7
Views
3K
Compute the useable power in a simple circuit with resistive vs. reactive loads
Replies
15
Views
2K

Hot Threads

Recent Insights

Back
Top