General information on back pressure in a syringe

AI Thread Summary
Back pressure in a syringe occurs when the plunger is depressed and then released, causing it to move back slightly due to the pressure changes. The behavior differs between syringes filled with air and those filled with water, as air is compressible while water is not. When pressure is applied to air, its volume decreases, leading to a back pressure effect governed by Boyle's law. Resources on this topic can be found in introductory physics textbooks and by searching for terms like "hysteresis." Understanding these principles can clarify the mechanics of back pressure in syringes.
Petra de Ruyter
Messages
24
Reaction score
1
Hi all

I'm looking for general information on "back pressure" specially in a syringe. So when you put your finger over the top of a syringe and depress the plunger then release the pressure on the plunger and the plunger moves back slightly. I'm struggling to find some specific information that will help me explain this scenario? So any reading that you think would be good please provide a link.

Cheers
 
Physics news on Phys.org
Hello Petra,

Did you notice a difference between syringes filled with air as opposed to syringes filled with water ?
 
This syringe is filled with air only and connected to another syringe that is empty. I'm looking for a text reading that will help me understand what is happening, I don't necessary need anything solved just need a good resource that I can refer to.
 
Air is compressible: when you increase the pressure (push down the syringe) the volume decreases. The air in the reduced volume presses back.
When all this is done at approximately the same temperature, the product of air volume (in the two syringes combined) and pressure is constant (Boyle-Gay Lussac law). Google or look it up in an introductory physics textbook.
 
  • Like
Likes dextercioby
Also, Google "hysteresis." You haven't identified/specified seal type.
 
Many thanks to all that have posted.
 
The rope is tied into the person (the load of 200 pounds) and the rope goes up from the person to a fixed pulley and back down to his hands. He hauls the rope to suspend himself in the air. What is the mechanical advantage of the system? The person will indeed only have to lift half of his body weight (roughly 100 pounds) because he now lessened the load by that same amount. This APPEARS to be a 2:1 because he can hold himself with half the force, but my question is: is that mechanical...
Some physics textbook writer told me that Newton's first law applies only on bodies that feel no interactions at all. He said that if a body is on rest or moves in constant velocity, there is no external force acting on it. But I have heard another form of the law that says the net force acting on a body must be zero. This means there is interactions involved after all. So which one is correct?
Thread 'Beam on an inclined plane'
Hello! I have a question regarding a beam on an inclined plane. I was considering a beam resting on two supports attached to an inclined plane. I was almost sure that the lower support must be more loaded. My imagination about this problem is shown in the picture below. Here is how I wrote the condition of equilibrium forces: $$ \begin{cases} F_{g\parallel}=F_{t1}+F_{t2}, \\ F_{g\perp}=F_{r1}+F_{r2} \end{cases}. $$ On the other hand...
Back
Top