How can I accurately measure force using a pressure sensor?

AI Thread Summary
To accurately measure force using a pressure sensor in a shoe prototype, one approach involves placing a rubber tube that bends under pressure. The pressure within the tube will not be uniform due to the rubber's expansion with pressure, complicating calculations. Instead of relying solely on a pressure gauge, considering a piston or mechanical spring for force measurement may yield better results. A nonlinear pressure vs. force curve will depend on the tube's geometry and material properties. Exploring additional resources, such as studies on piezoelectric film sensors, can provide further insights into effective pressure measurement techniques.
Kasper86
Messages
11
Reaction score
0
Hi guys
I hope you can help me a bit to understand a problem.

I want to build a prototype of an insole/shoe which can meassure the force applied through a step.

I´m thinking of placing a small rubber tube into the shoe, and then bending it smoothly a lot of times, so it will cover most of the insole.
Then I would hook it up with a pressure gauge like this: http://dk.rs-online.com/web/p/tryksensorer/7191055/ , and use Arduino to send my readings to Matlab.

But I´m not sure I understand how the pressure will be in the tube. I guess the pressure will be equal on every small area of the tube and therefore also the same at the meassuring point of the gauge?
Lets say that the inner diameter of the tube is 0.5inch^2, and the total force on the tube is 500N.
These pressure gauges have a limit around 50-100kPa, and my question is then, how would you calculate the pressure affecting the gauge - so I just don't buy the parts and ruin them.

If there is anything I´m missing, please let me know :)

Best regards - Kasper
 
Engineering news on Phys.org
Calculating pressure from the geometry you've described would be difficult, because rubber expands with pressure as well. Your pressure vs. force curve would be a nonlinear curve and dependent on geometry and material properties of the tube. You may be better off designing a piston in the shoe which compresses; or alternatively you might be able to use a mechanical spring and measure its dimensional compression.
 
Thank your for your replies. I had not thougt of the rubber exspansion :(
I´ll will look into the article you have mentioned. Thank you :)
 
Here's a video by “driving 4 answers” who seems to me to be well versed on the details of Internal Combustion engines. The video does cover something that's a bit shrouded in 'conspiracy theory', and he touches on that, but of course for phys.org, I'm only interested in the actual science involved. He analyzes the claim of achieving 100 mpg with a 427 cubic inch V8 1970 Ford Galaxy in 1977. Only the fuel supply system was modified. I was surprised that he feels the claim could have been...
TL;DR Summary: Heard in the news about using sonar to locate the sub Hello : After the sinking of the ship near the Greek shores , carrying of alot of people , there was another accident that include 5 tourists and a submarine visiting the titanic , which went missing Some technical notes captured my attention, that there us few sonar devices are hearing sounds repeated every 30 seconds , but they are not able to locate the source Is it possible that the sound waves are reflecting from...
Back
Top