How Do You Calculate Output Voltage in a Circuit Analysis Problem?

2 replies · 3K views · last reply
Studious_stud
Messages
38
Reaction score
0

Homework Statement



Find the output voltage vo in the following circuit
Two separate circuit diagrams side by side. Left: a 3 V source with + on top in series with a 1 kΩ resistor, current i1 marked on the top wire. Right: a dependent voltage source 7i1 in series with a 3 kΩ resistor and a 10 kΩ resistor, output voltage vo marked across the 10 kΩ resistor.


Homework Equations



V = IR



The Attempt at a Solution



Ok well I've been going over a couple more questions before my exam in introductory circuit analysis and here's another one I've never really seen before. This may sound stupid but the fact that it's like two different circuits is kind of confusing me.

Could someone at least point me in the right direction towards solving this problem? Really appreciate it everyone, thanks.
 
Studious_stud said:

Homework Statement



Find the output voltage vo in the following circuit
Circuit diagram with two parts: left, a 3 V source with a 1 kΩ resistor and current i1 marked in the loop; right, a dependent voltage source 7i1 in series with a 3 kΩ and a 10 kΩ resistor, with output voltage v_o across the 10 kΩ resistor.


Homework Equations



V = IR



The Attempt at a Solution



Ok well I've been going over a couple more questions before my exam in introductory circuit analysis and here's another one I've never really seen before. This may sound stupid but the fact that it's like two different circuits is kind of confusing me.

Could someone at least point me in the right direction towards solving this problem? Really appreciate it everyone, thanks.

It's all one circuit, actually. The left part defines the current, which is then used in the right circuit's "current controlled voltage source". So solve for the current in the left circuit first, and then use that current to set the voltage of the voltage source, and then solve for the voltage divider in the right circuit to get the output voltage.

Makes sense?
 
Last edited:
berkeman said:
It's all one circuit, actually. The left part defines the current, which is then used in the right circuit's "current controlled voltage source". So solve for the current in the left circuit first, and then use that current to set the voltage of the voltage source, and then solve for the voltage divider in the right circuit to get the output voltage.

Makes sense?

Perfect sense, thanks!

EDIT: Just did the calculation and got the correct answer. Thanks for the help again
 
Last edited: