How to Calculate Load on Idler in Belt Friction System?

AI Thread Summary
To calculate the load on the idler in a belt friction system, first sum the two load vectors. The calculation involves taking the square root of 2 multiplied by the result from part b. This approach simplifies the process of determining the idler load. Understanding these steps is crucial for accurate calculations in belt friction systems. Properly applying these methods will lead to effective load management.
SamMcCrae
Messages
8
Reaction score
0
I've done part a) and b) but I have no idea where to even begin with part c) on figuring out the loading on the idler!
 

Attachments

  • idler.JPG
    idler.JPG
    34.2 KB · Views: 572
Engineering news on Phys.org
The square root of 2 times the answer you got on (b).

Just sum the two load vectors up.
 
Pkruse said:
The square root of 2 times the answer you got on (b).

Just sum the two load vectors up.

That makes sense, thanks!
 

Thread 'Race car suspension Class'

Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
View full post »
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
View full post »

Thread 'Cantilever help'

I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
View full post »

Similar threads

Are Subaru 2.5 SOHC Cog Idlers the Same for Both Timing Belt Designs?
Replies
8
Views
2K
Is Upgrading to a Wider Conveyor Belt Worth the Investment?
Replies
4
Views
1K
Air Cylinder connected to a Lever that drives a Pulley for Applying Belt Tension
Replies
4
Views
3K
Calculate drive torque for rotating large drums
Replies
12
Views
3K
Gear Wear Rig Design: Calculating Load for Maximum Durability
Replies
6
Views
2K
How to Measure Torque Required for motor to spin a rotating shaft?
Replies
3
Views
4K
Torque calculations: Rotating vertical shaft
Replies
5
Views
5K
How to determine a load for belt tensioner
Replies
3
Views
5K
3D Printer Stepper Motor Torque Requirements Using Gear Reduction
Replies
1
Views
2K
G-load for an impact (shop cart hitting an immovable stop)
Replies
29
Views
2K

Hot Threads

Recent Insights

Back
Top