How to make a remote control on / off switch

AI Thread Summary
To create a remote control on/off switch for a string of low-voltage LEDs, users suggest repurposing existing devices like a cheap remote-controlled car or a remote dimmer switch. Hacking an R/C car is highlighted as a simple and effective solution, avoiding the complexities of building a circuit from scratch. Participants emphasize the importance of being cautious in public spaces to prevent unintended activations. The discussion reveals a preference for practical, accessible methods over more complicated DIY approaches. Overall, repurposing existing technology is seen as a viable route for achieving the desired remote control functionality.
John Readman
Messages
7
Reaction score
0
Hi all,

I would like to make a simple remote control on / off switch. It is for a string of LV leds. 12 V and 0.24 amp running from a battery supply.

I would simply like remote switch instead of a toggle so no one else can fiddle with it.

Can anyone help me, I have been scouring the internet but can find little advice...

Thanks,

John
 
Engineering news on Phys.org
Once I needed a remote controlled circuit, and I bought a $2.99 R/C car and hacked it. It was way easier than making one from scratch. Just avoid parks and place with kids or be prepared for many undesired triggerings.
 
Hi Sakha,
This is a very good idea. I had been thinking about pulling apart a remote dimmer switch for interior lighting. Your way sounds more fun.
 

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'Following up on the recent thread about Earth Resistance measurements'

I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
View full post »

Thread 'Question about bonding ground and neutral'

I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
View full post »

Similar threads

How to make a short range, remote-controlled electromagnet?
Replies
3
Views
5K
Replacing a remote with a switch -- voltage drop problems :(
Replies
2
Views
2K
Adding a remote switch to my electric scooter
Replies
10
Views
3K
Linear moving switch, decade counter, chaser
Replies
49
Views
4K
Whacking a Li-Ion battery
Replies
12
Views
2K
Switching between parallel and series connections (solar)
Replies
31
Views
4K
12V DC Motor in Light Fixture with Dimmer & 12V DC to 110V AC Inverter
Replies
21
Views
2K
How can I reroute multiple signals from a 4 pin connector using a relay switch?
Replies
37
Views
6K
Building a Simple Remote-Controlled Switch
Replies
9
Views
3K
Can a voltmeter help troubleshoot a ceiling fan remote control battery issue?
Replies
2
Views
3K

Hot Threads

Recent Insights

Back
Top