Hurricane wind blowing across a flat roof

AI Thread Summary
A hurricane wind of 180 km/hr affects a flat roof measuring 7.8 m x 12 m, prompting a discussion on calculating pressure difference and force exerted. The initial calculations were incorrect due to improper unit usage and incomplete equations. After reevaluating, the pressure change was determined to be 1625 Pa. This value was then used to calculate the force on the roof, resulting in a force of 152,100 N. The final calculations confirmed the accuracy of the results.
xKalax
Messages
2
Reaction score
0
1.A hurricane wind blows across a 7.8 m x 12 m flat roof at a speed of 180 km/hr.

What is the pressure difference?

How much force is exerted on the roof?
2. Homework Equations

P= p_atmos + pgd
P=F/A

The Attempt at a Solution


p = 101300Pa - (1.3)(9.8m/s^2)(93.6m^2)
p = 100107.5Pa

100107.5Pa = F/(93.6m^2)^2
F = 8.8 * 10^8 N

I know this is wrong, how do I go about solving this problem?
 
Last edited:
Physics news on Phys.org
That's not the right equation. Rather, it's not the entire equation.

First of all, the numbers you used don't even turn out to have the right units. As in, d = 93.6 m^2 doesn't have the right units for d.

And think about it, the speed is given for a reason. Get the full equation, and plug in the values, and easily get the answer.
 
ok, I got the change in pressure to be 1625 Pa, which is correct.

I plug that into F = pA and get F = 1625Pa * 93.6m^2 = 152100, this seems too big.

I got it right, thank you!
 
Last edited:
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
Back
Top