I wanted to know that what exactly is Knocking in an engine cylinder.

  • Thread starter Thread starter cyborgyash
  • Start date Start date
  • Tags Tags
    Cylinder Engine
AI Thread Summary
Knocking in an engine cylinder, also known as detonation, is a significant issue that can severely damage the engine. It occurs when the ignition timing is excessively advanced, leading to premature combustion. Other causes include mechanical faults, high boost pressure, elevated charge air temperatures, and improper air-fuel ratios. Fuel quality, particularly its knock resistance, also plays a crucial role in preventing knocking. Understanding these factors is essential for maintaining engine health and performance.
cyborgyash
Messages
6
Reaction score
0
I wanted to know that what exactly is Knocking in an engine cylinder. I know it's a kind of a fault. But how and whole process leading to it is, what i want to know.
Any reply will be well appreciated.

:D
Yash
 
Engineering news on Phys.org


Thanks !
But, i was looking forward for some users self explained answer.
 


it is DETONATION...big time problem and not good for the life of the engine.It is caused by ignition timing being advanced too much, over heating which causes vapor lock..i blew up aqn engine once when towing the race car trailer due to this.
 


The Wikipedia article sums it up very well, I'm not sure why you need anyone here to type out the same information. Read it, digest it, and if you still have questions come back and you'll get the help you need.

It's not only caused by advanced ignition timing, but can be caused by a mechanical fault, high boost pressure, high charge air temperature, low/high air fuel ratio (depending on fuel type), fuel with inadequate knock resistance and a few other factors. It's also normally the primary limitation on the rating of a spark ignition engine.
 
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'
Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly

Similar threads

Back
Top