Impedance equivs and complex numbers.

AI Thread Summary
Equivalent impedances in circuits can be calculated by finding a common denominator and adding the terms, while remembering that j*j = -1. Rationalizing the denominators by using the complex conjugate simplifies the process, allowing for the addition of real and imaginary parts. For the given example, the calculation leads to an equivalent impedance of approximately 0.3331 - 25.49j. Another method involves converting Cartesian impedances into polar admittances for addition, then converting back to obtain the equivalent impedance. Multiple approaches exist for these calculations, and the choice of method may vary based on individual preference.
seang
Messages
184
Reaction score
0
Hey, I'm finding equivalent impedances of circuits, and I always run into things like this:

1/(-j25) + 1/(600 +j900) = 1/Zeq

I don't know how to proceed from here. I know this is more of a math issue than anything else, but I appreciate your help
 
Engineering news on Phys.org
Just put them over a common denominator and add. Remember that j*j=-1 and you should be fine.
 
What works best for me is to rationalise the denominators (by multiplying numerator and denominator by the complex conjugate of the denominator) then simply adding real and imaginary parts. After rationalising, the denominator will be the square of the modulus while the numerator will be the conjugate. Also, remember that 1/j = -j.
So for your example you would go:
1/(-j25) + 1/(600 +j900) = j/25 + (600 - 900j)/(600^2 + 900^2) = 600/1170000 + (1/25 - 900/1170000)j = 1/1950 + j51/1300 = 1/Z
-> Z = 1/(1/1950 + j51/1300) = (1/1950 - j51/1300)/(1/1950^2 + (51/1300)^2) = 0.3331 - 25.49j
Alternatively, you could convert the cartesian impedances into polar admitances then add them (admitances in parallel add) and put the result into polar form and invert to obtain the equivalent impedance.
There are many ways of doing these calculations. I'm not sure which is quickest.
 
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
Back
Top