Impulse of Cricket Homework: Find Magnitude

  • Thread starter Thread starter odie5533
  • Start date Start date
  • Tags Tags
    Impulse
AI Thread Summary
The discussion focuses on calculating the impulse of a cricket that jumps a horizontal distance of 2.55 m at a 30-degree angle. The initial velocity needed for the jump is determined to be approximately 5.37 m/s, leading to an impulse calculation of 107.47 g·m/s. Participants express confusion regarding the homework question's wording, suggesting it should clarify the request for impulse and total force, as the time of 0.019 seconds is not utilized in the impulse calculation. It is noted that while time is not necessary for impulse, it is relevant for calculating total force. The importance of using SI units and converting mass to kilograms is also emphasized.
odie5533
Messages
58
Reaction score
0

Homework Statement


A 20g cricket leaps through a 2.55 m horizontal distance. The initial velocity of the cricket makes an angle of 30 degress with the horizontal direction. If it takes the cricket 0.019s to leave the ground, what is the magnitude of the impulse of the total force on the cricket that gives it the speed needed for the jump?

The Attempt at a Solution


I started by finding the velocity needed for the jump:
V_{y} = VSin30=\frac{1}{2}V
y = \frac{1}{2}Vt-\frac{1}{2}gt^2
Set to 0 to find when he lands:
0 = \frac{1}{2}Vt-\frac{1}{2}gt^2
t = \frac{V}{g}

V_{x} = VCos30
x(t) = (VCos30)t
Set to 2.55, the horizontal distance traveled when he lands:
2.55=\frac{V^2}{g}Cos30
V=\sqrt{\frac{2.55 g}{Cos30}} = 5.3736 m/s

So, the inital momentum is 0, since his velocity before the jump is 0.
J = mv_{2} - mv_{1} = mv_{2} - 0 = (20 g)(5.3736 m/s) - 0 = 107.47

I never liked impulse/momentum problems, and I was wondering if any of the above is correct. I just plugged numbers into the formulas and have no idea if I did it right =/ Also, I didn't use the time of 0.019s anywhere.
 
Physics news on Phys.org
odie5533 said:

Homework Statement


A 20g cricket leaps through a 2.55 m horizontal distance. The initial velocity of the cricket makes an angle of 30 degress with the horizontal direction. If it takes the cricket 0.019s to leave the ground, what is the magnitude of the impulse of the total force on the cricket that gives it the speed needed for the jump?
The question does not quite make sense (the last part). Are you sure it was not "what is the magnitude of the impulse and of the total force..." ?

The Attempt at a Solution


I started by finding the velocity needed for the jump:
V_{y} = VSin30=\frac{1}{2}V
y = \frac{1}{2}Vt-\frac{1}{2}gt^2
Set to 0 to find when he lands:
0 = \frac{1}{2}Vt-\frac{1}{2}gt^2
t = \frac{V}{g}

V_{x} = VCos30
x(t) = (VCos30)t
Set to 2.55, the horizontal distance traveled when he lands:
2.55=\frac{V^2}{g}Cos30
V=\sqrt{\frac{2.55 g}{Cos30}} = 5.3736 m/s

So, the inital momentum is 0, since his velocity before the jump is 0.
J = mv_{2} - mv_{1} = mv_{2} - 0 = (20 g)(5.3736 m/s) - 0 = 107.47

I never liked impulse/momentum problems, and I was wondering if any of the above is correct. I just plugged numbers into the formulas and have no idea if I did it right =/ Also, I didn't use the time of 0.019s anywhere.

I did not check all the numbers but the reasoning is good. If they ask for the magnitude of the total force this is where the delta time would come up. I am pretty sure this is what they were asking.
 
I copied the question word for word. It took me a long time to figure out what it was asking, and I agree it makes more sense for it to be and. Ah well, my professor is notorious for typos and unanswerable questions, so this must just be another one. Thanks for the help.
 
odie5533 said:
I copied the question word for word. It took me a long time to figure out what it was asking, and I agree it makes more sense for it to be and. Ah well, my professor is notorious for typos and unanswerable questions, so this must just be another one. Thanks for the help.
Ok. For the impulse itself no time is required.
I just noticed: write the units on your final answer. And if you want it in SI units, you better convert the mass to kilograms.
 
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Trying to understand the logic behind adding vectors with an angle between them'
My initial calculation was to subtract V1 from V2 to show that from the perspective of the second aircraft the first one is -300km/h. So i checked with ChatGPT and it said I cant just subtract them because I have an angle between them. So I dont understand the reasoning of it. Like why should a velocity be dependent on an angle? I was thinking about how it would look like if the planes where parallel to each other, and then how it look like if one is turning away and I dont see it. Since...
Back
Top