Initial velocity of the golf ball

AI Thread Summary
The discussion revolves around solving a physics problem related to the initial velocity of a golf ball hit by Tiger Woods, aiming for maximum distance. Participants emphasize the need for assumptions about the angle of launch to determine the initial velocity, maximum height, time to reach maximum height, and total travel time. The conversation also touches on a separate problem involving crossing a river, highlighting the importance of vector analysis for calculating the boat's trajectory and speed. Key points include the relationship between launch angle and distance, as well as the application of trigonometric functions to solve the problems. Understanding these principles is crucial for accurately solving both scenarios.
flamegrl
Messages
2
Reaction score
0
Hey guys
I am kinda new do this forum,
but if anyone can help me one this IT would be great
I have this homework problem I tryed many times but can't figure it out,

Tiger Woods can routinely hit a gofl ball 350-yards(320m) assuming he hits at an angle that gives him maxium distance solve the following:
1. initial velocity of the golf ball
2. what is the Maxium height of the golf ball
3. how long does it take to reach the maxium height
4. how ling does it take to travel the 350 yards
 
Physics news on Phys.org
flamegrl said:
Hey guys
I am kinda new do this forum,
but if anyone can help me one this IT would be great
I have this homework problem I tryed many times but can't figure it out,

Tiger Woods can routinely hit a gofl ball 350-yards(320m) assuming he hits at an angle that gives him maxium distance solve the following:
1. initial velocity of the golf ball
2. what is the Maxium height of the golf ball
3. how long does it take to reach the maxium height
4. how ling does it take to travel the 350 yards

Is that all the information given? Because that is an impossible problem unless you make an assumption that no matter the angle, the force exerted on the ball would be the same.

Hint: The maximum distance will be found when both components of the velocity are equal. Think if you hit the ball with force F, at angle 80 degrees, then the x component would be much smaller then the y. So the ball would not travel very far. While if you hit the ball with same force F at angle 30 degrees, with a much higher x component for its velocity, the ball would travel much farther. However the lowest angles will not produce the farthest distance, thanks to gravity.
 
Last edited:
Yes that was all the information give!

but I also am having trouble with this one as well
while fishing on a rather hot day you decide, beacuse of the fish aren't biting, to take a break and go to the 7-11 across the river flowing at 4m/s. the river is 500m wide
1. if the boat can travel at 7m/s how long does it take until you reach the other side of the river
2. in what direction relative to the shore must you steer your boat to go straight to the 7-11 the boat is facing north-eat
 
You have all the information needed to solve the golf ball problem. Hint: What angle gives the maximum range?
 
flamegrl said:
Yes that was all the information give!

but I also am having trouble with this one as well
while fishing on a rather hot day you decide, beacuse of the fish aren't biting, to take a break and go to the 7-11 across the river flowing at 4m/s. the river is 500m wide
1. if the boat can travel at 7m/s how long does it take until you reach the other side of the river
2. in what direction relative to the shore must you steer your boat to go straight to the 7-11 the boat is facing north-eat

Vectors! Just use vectors for the individuals forces, and make a diagram of them.

sin\theta = \frac{Current}{Speed of Boat}
 
I multiplied the values first without the error limit. Got 19.38. rounded it off to 2 significant figures since the given data has 2 significant figures. So = 19. For error I used the above formula. It comes out about 1.48. Now my question is. Should I write the answer as 19±1.5 (rounding 1.48 to 2 significant figures) OR should I write it as 19±1. So in short, should the error have same number of significant figures as the mean value or should it have the same number of decimal places as...
Thread 'A cylinder connected to a hanging mass'
Let's declare that for the cylinder, mass = M = 10 kg Radius = R = 4 m For the wall and the floor, Friction coeff = ##\mu## = 0.5 For the hanging mass, mass = m = 11 kg First, we divide the force according to their respective plane (x and y thing, correct me if I'm wrong) and according to which, cylinder or the hanging mass, they're working on. Force on the hanging mass $$mg - T = ma$$ Force(Cylinder) on y $$N_f + f_w - Mg = 0$$ Force(Cylinder) on x $$T + f_f - N_w = Ma$$ There's also...
Back
Top