Is Hydrogen Peroxide Vapor from Decomposition Harmful?

  • Thread starter Thread starter Dolby
  • Start date Start date
  • Tags Tags
    Catalyst Safety
AI Thread Summary
The discussion centers on conducting experiments with hydrogen peroxide at varying concentrations (5-60%) and the associated risks, particularly regarding inhalation of harmful vapors. The original poster seeks advice on safety precautions, specifically in well-ventilated outdoor settings. Concerns are raised about the dangers of scaling up experiments without sufficient knowledge and experience. One participant shares their previous experience with 10% hydrogen peroxide, noting that decomposition primarily produces steam and oxygen, questioning the potential for harmful byproducts at higher concentrations. Ultimately, the conversation emphasizes the importance of safety and caution when handling hazardous materials, leading to a decision to lock the thread due to the perceived risks involved.
Dolby
Messages
2
Reaction score
0
Hello, I will be experimenting with hydrogen peroxide from 5-60% concentrations and small amounts of alkaline metals to measure how much gas is produced in under 5 min. I understand that hydrogen peroxide is a dangerous chemical if not handled right. My question is that on the MSDS it says that it gives off a vapor that is harmful if inhaled, has anyone had any experience with this (like tips) and is this something I should take extreme precaution with or will I be okay if I have a well ventilated area? (outdoors)

Also on a side note if the hydrogen peroxide vapor is harmful will the gas from decomposition be just as harmful or not harmful at all?
 
Chemistry news on Phys.org
For me your question shows you should not do these experiments, as they are too dangerous for your level of knowledge and experience.
 
Well no offense but we all need to start somewhere to gain the knowledge and experience. I have already experimented several times with h2o2 using up to 10% concentration. From those experiments I have determined that when it decomposes it only produces steam (water, heat) and oxygen. What I'm trying to understand is that before I start with more concentrations is there any thing else it could make this harmful inhalation wise?
 
Yes, you have to start somewhere, but scaling up dangerous experiments without a LOT of experience is a bad idea. Sorry, this is a dangerous activity, I am locking the thread.

Please read chemistry forum rules.
 
I want to test a humidity sensor with one or more saturated salt solutions. The table salt that I have on hand contains one of two anticaking agents, calcium silicate or sodium aluminosilicate. Will the presence of either of these additives (or iodine for that matter) significantly affect the equilibrium humidity? I searched and all the how-to-do-it guides did not address this question. One research paper I found reported that at 1.5% w/w calcium silicate increased the deliquescent point by...
Back
Top