Is My Solution to Circular Motion Problem Correct?

AI Thread Summary
The discussion revolves around a circular motion problem involving a car moving on a hilly road with a radius of 250 meters. For part (a), the normal force at the crest is calculated to be 8 kN, and the normal force at the bottom of the dip is determined to be 24 kN. In part (b), the maximum speed at which the car can travel without losing contact at the top of the hill is found to be 50 m/s. Part (c) calculates the normal force at the bottom of the dip when traveling at this maximum speed, resulting in a force of 32.3 kN. The calculations and reasoning presented are generally confirmed as correct by other participants in the discussion.
bob1182006
Messages
491
Reaction score
1
Halliday & Resnick 5e Chapter 5 Problem 14

Homework Statement


A car moves at some constant speed on a straight but hilly road. One section has a crest and dip of the same 250-m radius.
(a). as the car passes over the crest, the normal force on the car is 1/2 the 16-kN weight of the car. What will be the normal force on the car as it passes through the bottom of the dip?
(b). What is the greatest seed at which the car can move without leaving the road at the top of the hill?
(c). Moving at the speed found in (b) what will be the normal force on the car as it moves through the bottom of the dip?


Homework Equations


Fnet=ma
a=v^2/R

The Attempt at a Solution


a.
on the crest:
Normal Force up, weight down, acceleration down
N-mg=-ma
\frac{-N}{m}+g=\frac{v^2}{R}
N=.5mg
\frac{N}{m}=\frac{.5mg}{m}
N/m=.5g
R(-.5g+g)=v^2
v=\sqrt{.5gR}
v=35 m/s

v constant so can use it to find N during the dip.

on the dip:
Normal Force up, weight down, Acceleration Up
N-mg=ma
N=m(g+a)
N=m(g+\frac{v^2}{R}
N=1/2mg
m=2N/g
N=\frac{2N}{g}(g+\frac{v^2}{R}
plugging in I get N=24N

b.
The greatest v that the car can reach will be enough to give N=0?
x: ma_x=0
y: N-mg=-ma_y
N-mg=-m\frac{v^2}{R}
g=\frac{v^2}{R}
v^2=gR
|v|=\sqrt{gR}
plugging in v=50 m/s

c.
x: ma_x=0
y: N-mg=ma_y
N=m(a_y+g)
N=m(\frac{v^2}{R}+g)
N=\frac{W}{g}(\frac{v^2}{R}+g)
N=\frac{Wv^2}{gR}+W
plugging in I get N=32.3 kN

Thanks in advance, was reviewing and couldn't repeat my reasoning on this problem :s.
 
Physics news on Phys.org
For part a remember that the cars weight is in kN not just N. Otherwise its a bit messy but looks ok.

Part b looks fine as well.

Part c also looks ok.
 
Thread 'Variable mass system : water sprayed into a moving container'
Starting with the mass considerations #m(t)# is mass of water #M_{c}# mass of container and #M(t)# mass of total system $$M(t) = M_{C} + m(t)$$ $$\Rightarrow \frac{dM(t)}{dt} = \frac{dm(t)}{dt}$$ $$P_i = Mv + u \, dm$$ $$P_f = (M + dm)(v + dv)$$ $$\Delta P = M \, dv + (v - u) \, dm$$ $$F = \frac{dP}{dt} = M \frac{dv}{dt} + (v - u) \frac{dm}{dt}$$ $$F = u \frac{dm}{dt} = \rho A u^2$$ from conservation of momentum , the cannon recoils with the same force which it applies. $$\quad \frac{dm}{dt}...
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
Back
Top