Kinetic Energy of Rolling Motion

AI Thread Summary
The discussion revolves around calculating the kinetic energy of a rotating CD with a mass of 12g and a radius of 7.0 cm, rotating at an angular speed of 35 rad/s. The user initially applied the formula K=(1/2)mv^2(1+I/mr^2) but made an error in the calculation, resulting in an incorrect answer. After receiving feedback, they realized they forgot to multiply by 1/2 in their calculations. The correct approach for rotational kinetic energy is to use K = (1/2) I ω^2, highlighting the importance of careful unit tracking and formula application. The user ultimately corrected their mistake with assistance from others in the discussion.
Cici2006
Messages
7
Reaction score
0

Homework Statement


A 12g CD with a radius of 7.0 cm rotates with an angular speed of 35 rad/s.
What is its kinetic energy?


Homework Equations





The Attempt at a Solution


I used K=(1/2)mv^2(1+I/mr^2)
v=\omegar=(35rad/s)(0.07m)=2.45m/s
K=(1/2)(0.012kg)(2.45m/s)^2(1)=0.36

And it's wrong. Am i using the right formula? What should I do
 
Physics news on Phys.org
For rotational KE, use:
{KE} = 1/2 I \omega^2
 
I used that too and i still got it wrong.
 
Are you keeping track of units. If its not the problem, just show your calculation
 
Oh I know what i did wrong now i forgot to multiply by 1/2. THanks for the help
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top