Line-Line Fault Circuit: Parallel or Series?

2 replies · 2K views · last reply
Physicist3
Messages
103
Reaction score
0
Circuit schematic of two sequence networks joined by a fault impedance Zf: source 1.0 Pu with R1 and X1 feeding node F1, and R2 and X2 at node F2, with nodes N1 and N2 connected by a return wire.
Hi,

When calculating a line-line fault, I understand that the Positive and Negative Phase Sequence networks are placed in parallel with each other as shown in the first attached image, and that the zero phase sequence is excluded. Although this is connected in parallel, does it not produce a series circuit such as the one shown in the second attachment?

Single-line circuit diagram with a 1.0 Pu source on the left feeding a series path of R1, jX1, Zf, R2 and jX2 in a loop, with voltage arrows labelled Va1 and Va2 marked at two points.
 
Thanks for the post! Sorry you aren't generating responses at the moment. Do you have any further information, come to any new conclusions or is it possible to reword the post?
 
Physicist3 said:
View attachment 75220 Hi,

When calculating a line-line fault, I understand that the Positive and Negative Phase Sequence networks are placed in parallel with each other as shown in the first attached image, and that the zero phase sequence is excluded. Although this is connected in parallel, does it not produce a series circuit such as the one shown in the second attachment?

View attachment 75221
As you said, equivalent positive and negative phase seq. networks can be placed in parallel when considering this fault. However, this doesn't produce a series circuit of all the impedances fed by emf "e" since currents in different parts of new network are generally different (i1≠i2≠if).BTW, if you calculate in p.u. system, all voltages,currents,impedances must be in p.u., and denoted in small letters. I have modified your schematic accordingly:
Circuit schematic of two sections joined by a fault impedance z_f: left source e with r1 and jx1 to node F1, right section r2 and jx2 to node F2, return paths to N1 and N2, with currents i1, i2 and voltages v1, v2 marked and 1.0 Pu labelled on the source.