Looking for a voltage to current IC

yungman
Messages
5,741
Reaction score
294
I am looking for an IC that convert input voltage to a current. Any suggestion?
 
Engineering news on Phys.org
Thread 'Weird near-field phenomenon I get in my EM simulation'

Thread 'Weird near-field phenomenon I get in my EM simulation'

I recently made a basic simulation of wire antennas and I am not sure if the near field in my simulation is modeled correctly. One of the things that worry me is the fact that sometimes I see in my simulation "movements" in the near field that seems to be faster than the speed of wave propagation I defined (the speed of light in the simulation). Specifically I see "nodes" of low amplitude in the E field that are quickly "emitted" from the antenna and then slow down as they approach the far...
View full post »

Thread 'EMF (Electromagnetic Field) & EHS (Electromagnetic Hyper Sensitivity)'

Hello dear reader, a brief introduction: Some 4 years ago someone started developing health related issues, apparently due to exposure to RF & ELF related frequencies and/or fields (Magnetic). This is currently becoming known as EHS. (Electromagnetic hypersensitivity is a claimed sensitivity to electromagnetic fields, to which adverse symptoms are attributed.) She experiences a deep burning sensation throughout her entire body, leaving her in pain and exhausted after a pulse has occurred...
View full post »

Similar threads

Simulated voltage gain in Multisim differs very much from calculated
Replies
8
Views
1K
Composite signal generation IC in DIFAR Sonobuoys
Replies
11
Views
2K
Synchronous MOSFET Driver not functioning when voltage already present
Replies
2
Views
2K
Optimizing Phase Current Measurements with Shunt Resistors
Replies
6
Views
1K
Is There an IC for Instant On-Delay Off Circuits?
Replies
7
Views
2K
Counting of Integrated Circuits by photo or video
Replies
7
Views
2K
Understanding BJT Common Collector Circuit: Voltage and Saturation Explanation
Replies
10
Views
2K
Signal Distribution ICs - 200-300V Input, Output Port Selection
Replies
2
Views
2K
Using delicate 5V IC to toggle 12V device with MOSFET, Diode, resistor
Replies
8
Views
1K
How EMI is handled in IC fabrication?
Replies
14
Views
1K

Hot Threads

Recent Insights

Back
Top