Masses on incline plane and pulley.

AI Thread Summary
The discussion centers on a physics problem involving a system of three masses connected by pulleys, with one mass moving up and two moving down an incline with friction. The user sets up a force equation to find the system's acceleration, incorporating gravitational forces and friction. After calculating, they find the acceleration to be 3.43 m/s². The user realizes they initially overlooked the parallel force component in their calculations. Ultimately, they confirm their solution is correct and express satisfaction with resolving the issue.
i<3physics
Messages
2
Reaction score
0

Homework Statement



A suspended 2.87 kg mass is moving up, a 1.5 kg mass slides down the ramp, a suspended 8.4 kg mass on the left is moving down. There is friction between the block and the ramp. The acceleration of gravity is 9.8 m/s2 . The pulleys are massless and frictionless.

Find the acceleration of the 3 block system.
Here is a diagram

http://img8.yfrog.com/i/capturexki.jpg/


Homework Equations



F=ma
Friction=μN
F parallel: mgsinφ
F perpendicular: mgcosineφ

The Attempt at a Solution



Sumation equation I set up (mass 1= 8.4kg, mass 2=1.5kg, mass 3=2.87kg mt=total mass)

m1g-m2g(sinφ)-friction-m3g=mtg

after the numbers are plugged in:

(8.4)(9.8)-(1.5)(9.8)sin36-(0.14)(1.5)(9.8)cos36-2.87(9.8)=12.77a

acceleration would equal=3.43 m/s2

is this correct?
 
Last edited by a moderator:
Physics news on Phys.org
i think your attempt is exactly what the question required
 
I figured it out...

I was forgetting to add the parallel force to the driving force.

All is well now, thanks!
 
I multiplied the values first without the error limit. Got 19.38. rounded it off to 2 significant figures since the given data has 2 significant figures. So = 19. For error I used the above formula. It comes out about 1.48. Now my question is. Should I write the answer as 19±1.5 (rounding 1.48 to 2 significant figures) OR should I write it as 19±1. So in short, should the error have same number of significant figures as the mean value or should it have the same number of decimal places as...
Thread 'Calculation of Tensile Forces in Piston-Type Water-Lifting Devices at Elevated Locations'
Figure 1 Overall Structure Diagram Figure 2: Top view of the piston when it is cylindrical A circular opening is created at a height of 5 meters above the water surface. Inside this opening is a sleeve-type piston with a cross-sectional area of 1 square meter. The piston is pulled to the right at a constant speed. The pulling force is(Figure 2): F = ρshg = 1000 × 1 × 5 × 10 = 50,000 N. Figure 3: Modifying the structure to incorporate a fixed internal piston When I modify the piston...
Thread 'A cylinder connected to a hanging mass'
Let's declare that for the cylinder, mass = M = 10 kg Radius = R = 4 m For the wall and the floor, Friction coeff = ##\mu## = 0.5 For the hanging mass, mass = m = 11 kg First, we divide the force according to their respective plane (x and y thing, correct me if I'm wrong) and according to which, cylinder or the hanging mass, they're working on. Force on the hanging mass $$mg - T = ma$$ Force(Cylinder) on y $$N_f + f_w - Mg = 0$$ Force(Cylinder) on x $$T + f_f - N_w = Ma$$ There's also...
Back
Top