Maximizing Solar Still Output: Is There a Simple Equation?

AI Thread Summary
Modeling the output of a solar still based on tilt angle and location in Africa requires some basic mathematical understanding, which can be complex. While the desire to improve potable water access in arid regions is commendable, relying solely on online forums for simple equations may not yield effective results. Collaborating with technically skilled individuals or organizations could provide the necessary support and expertise. Seeking out resources or partnerships may be more beneficial than attempting to derive formulas independently. Engaging with knowledgeable communities can help turn the project into a reality.
Greenybwa
Messages
5
Reaction score
0
Hi,

Does anyone know of a way I can model the output of a solar still with a specific tilt angle and location (Africa) to give me my desired output value? I've been looking at lots of research papers but the maths is far too confusing for me to even begin to try work it out and I'm hoping there is a simple way that I can plug in numbers to an equation and get a semi accurate answer.

Thanks
 
Engineering news on Phys.org
Your previous thread about this topic/question for reference:

https://www.physicsforums.com/threads/glass-how-to-increase-the-surface-area.958616/#post-6078623

It sounds like you have good motivations, to try to provide more potable water in arid regions that are disadvantaged. But without some basic math skills, it may be hard for you to optimize a design. Have you tried looking for like-minded technical folks who could help you out? There have to be both individuals and foundations with the technical skills to help you make your project a reality. Asking for "formulas" in an Internet discussion forum is probably not the right way for you to pursue this project, IMO.
 
Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
Thread 'What's the most likely cause for this carbon seal crack?'
We have a molded carbon graphite seal that is used in an inline axial piston, variable displacement hydraulic pump. One of our customers reported that, when using the “A” parts in the past, they only needed to replace them due to normal wear. However, after switching to our parts, the replacement cycle seems to be much shorter due to “broken” or “cracked” failures. This issue was identified after hydraulic fluid leakage was observed. According to their records, the same problem has occurred...
Back
Top