Momentum eq for cylindrical element

shair44
Messages
6
Reaction score
0
Help!

I trying to improve momentum eq for cylindrical element coordinate by using vector method or may other methods

Please give me response v.ergent . Thanks! =)
 
Engineering news on Phys.org
by the way i am looking hwo to express the momentum eq for cylinder
 

Thread 'Race car suspension Class'

Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
View full post »
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
View full post »

Thread 'Cantilever help'

I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
View full post »

Similar threads

Finite element method approximation
Replies
0
Views
990
Angle of twist from in-plane displacements in FEA
Replies
5
Views
2K
[ANSYS] Meshing based on Keypoints
Replies
0
Views
1K
Pressure rate increase between two vessels
Replies
5
Views
2K
What is the most incompressible elastomer?
Replies
2
Views
1K
MCNP - z-coordinates of cylindrical mesh >0?
Replies
2
Views
2K
I Vector calculus: line element dr in cylindrical coordinates
Replies
11
Views
2K
Sound Generation from Fluid Flow
Replies
4
Views
2K
Pumping power calculation of a vertical closed-loop system
Replies
4
Views
3K
Inlet and outlet design for a cylindrical tank
Replies
4
Views
3K

Hot Threads

Recent Insights

Back
Top