Momentum problem involving collision of two balls

AI Thread Summary
The discussion revolves around solving a momentum problem involving the collision of two balls. The initial momentum is calculated as 8 kg*m/s by summing the momenta of both balls. The user is attempting to find the final momentum of a 3 kg ball moving at a 30-degree angle, resulting in x and y components of 1.50 kg*m/s and 2.60 kg*m/s, respectively. The user seeks confirmation on the correctness of their approach and the method for adding vector quantities, emphasizing the need to consider direction. The conversation highlights the importance of vector addition in momentum calculations, comparing it to navigating using map directions.
Joshpho
Messages
4
Reaction score
0

Homework Statement



(It includes a diagram so I'm just going to link it)
#22 from Chapter 7 of the People's Physics Book (second to last page, with the table)
http://scipp.ucsc.edu/outreach/07Momentum.pdf

Homework Equations



p(i)=p(f)
p(f)x=m*v*cosin(theta) [I "made these up", so to speak, but it seems logical]
p(f)y=m*v*sin(theta)

The Attempt at a Solution



The main trouble I am is with b), finding the actual direction of the 2 kg ball. First, however, I wanted to verify my steps so far is correct...

The initial momentum should be 8kg*m/s by summing the individual, positive momentums of each ball. For the final momentum of the 3 kg ball, I obtained them like so...

We know the angle is 30 degrees and it has a velocity of 1 m/s, so we know
Momentum in the x direction = 3kg*1m/s*cosin(30) = 1.50
Momentum y = 3kg*1m/s*sin(30) = 2.60

So now I set up our conservation equation like so...

8 kg*m/s = (1.50+2.60)kg*m/s + p(2kg ball)

Is this correct so far?
 
Physics news on Phys.org
momentum is a vector quantity. So does it make sense to sum the momenta of the two balls?
 
We know that the total momentum before compared to the final momentum has to be equal, so yes?
 
ok, so how do you add two vector quantities?
 
Finding the diagonal of the paralellogram they form? But this doesn't seem possible to do without knowing the direction of the 2kg ball first.

Also, you are allowed to add momentum quantities, right? I was taught you could do that at least, since they're both mass and speed.
 
momentum : mass speed and direction. When you add momenta together you must keep track of direction too. So yes you will be finding the diagonal of the parallelogram either explicitly or by keeping the components of the vector separate. Much like map directions where you can say go 1 mile East and 1 mile North or equivalently go 1.4 miles NorthEast. It works the other way too: Even though a bird can fly 1.4 miles due NE we may have to take the equivalent route by traveling 1 mile East and 1 mile North.

So what is your initial momentum for the two masses?
 
I multiplied the values first without the error limit. Got 19.38. rounded it off to 2 significant figures since the given data has 2 significant figures. So = 19. For error I used the above formula. It comes out about 1.48. Now my question is. Should I write the answer as 19±1.5 (rounding 1.48 to 2 significant figures) OR should I write it as 19±1. So in short, should the error have same number of significant figures as the mean value or should it have the same number of decimal places as...
Thread 'A cylinder connected to a hanging mass'
Let's declare that for the cylinder, mass = M = 10 kg Radius = R = 4 m For the wall and the floor, Friction coeff = ##\mu## = 0.5 For the hanging mass, mass = m = 11 kg First, we divide the force according to their respective plane (x and y thing, correct me if I'm wrong) and according to which, cylinder or the hanging mass, they're working on. Force on the hanging mass $$mg - T = ma$$ Force(Cylinder) on y $$N_f + f_w - Mg = 0$$ Force(Cylinder) on x $$T + f_f - N_w = Ma$$ There's also...
Back
Top