Solve NPN Transistor Puzzle: -0.4V?

AI Thread Summary
The discussion revolves around a puzzling scenario involving an NPN transistor where the base is grounded, and +12 volts is applied to the emitter through a 1k resistor, resulting in a collector voltage of approximately -0.4 volts. Participants express confusion over how this negative voltage occurs, particularly with the collector left open. It is noted that applying such reverse bias can damage most NPN transistors, especially with high voltages. Links to further reading on the topic are shared, highlighting the phenomenon's complexity and the potential for interesting effects. The conversation emphasizes the intriguing nature of the problem while cautioning about the risks to the transistor's functionality.
donpacino
Science Advisor
Gold Member
Messages
1,439
Reaction score
285
I was just sent an email with the following text.
""
Here is a puzzle I just encountered.

Take any NPN transistor and ground the base. Now apply +12 volts to the emitter through a series resistor of 1k. Yes, it is a Zener diode of about 6 volts so about 6 ma of current flows.What is the voltage between the collector and ground? I couldn't guess. Well I could guess it was zero volts, but then, that would not have been a puzzle. So I gave up.Answer: about -0.4 volts ! (Yes negative.) Why?
""I am at a loss for understanding where they are getting this supposed -0.4V. Any takers?

edit: it is important to note my interpretation of the problem is the the collector is left open
 
Engineering news on Phys.org
Cool problem. Amazing effect.
 
Note that most NPN transistors will be damaged by reverse biasing the E-B junction, especially with such large voltages. I'm not discouraging you from doing the experiment (these things are cheap, after all), but don't expect the transistor to function properly afterward.
 
meBigGuy said:
Cool problem. Amazing effect.
My thoughts exactly. Thanks for the links everyone. Great reads!
 

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'What happens if shielded cable has short to the shield?'

While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
View full post »

Thread 'Question about bonding ground and neutral'

I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
View full post »

Similar threads

NPN transistor and how it operates....
Replies
11
Views
2K
What Factors Determine the Selection of a High-Voltage NPN Transistor?
Replies
2
Views
1K
Understanding a heat sensor circuit?
Replies
3
Views
1K
Why does a transistor in saturation act like a short circuit?
Replies
5
Views
4K
Will the bleed resistors enable a shorter path to ground or not?
2
Replies
80
Views
5K
NPN Transistor: Collector Voltage Below Emitter Voltage?
Replies
5
Views
3K
Saturation region of transistor
Replies
7
Views
4K
NPN transistor model for use with differential equations-LC oscillator
Replies
4
Views
5K
Understanding BJT Common Collector Circuit: Voltage and Saturation Explanation
Replies
10
Views
2K
Connection of the transistor in the discharge path betn 7 & 6 of 555
Replies
1
Views
2K

Hot Threads

Recent Insights

Back
Top