Physics-Young's Double Slit Problem

  • Thread starter Thread starter frankene
  • Start date Start date
  • Tags Tags
    Double slit Slit
AI Thread Summary
The problem involves calculating the distance between the third-order red and yellow-green fringes in a double-slit experiment. The slits are 0.143 mm apart, with red light at 665 nm and yellow-green light at 565 nm. After calculating the angles for both wavelengths using the formula Theta = sin-1((m*lambda) / d), the user found the positions on the screen. The initial answer of 0.005 m was incorrect due to a miscalculation in the final conversion, which should have been 4.804 mm. The user successfully corrected the error and expressed relief at resolving the issue.
frankene
Messages
6
Reaction score
0
Hello! I am stuck on a problem that seems so easy. The question is:

Two slits are 0.143 mm apart. A mixture of red light (wavelength = 665 nm) and yellow-green light (wavelength = 565 nm) falls on the slits. A flat observation screen is located 2.29 m away. What is the distance on the screen between the third-order red fringe and the third-order yellow-green fringe?

I solved for Theta for both red light and the yellow-green light. (m = 3)

Theta = sin-1((m*lamda) / d)

Red: Theta = sin-1((3 * 665e-9) / .143e-3) = .799 degrees

Yellow-green: Theta = sin-1((3 * 565e-9) / .143e-3) = .679 degrees

From there I solved for the distance and subtracted the two:

y = L * tan theta

Red: y = 2.29 * tan(.799) = 0.032m

Yellow-green: y = 2.29 * tan(.679) = 0.027m

I get an answer of 0.005m but the site says my answer is wrong. Any hints as to what I am doing wrong?

Thank you for any help!
 
Physics news on Phys.org
try inputting your answer to the same degree of accuracy as the slit seperation, try 4.804 mm
 
Thank you! It had to be in meters so it took 4.804e-3 meters! I am glad it was an easy fix. I thought I had a grasp of this concept and I was frustrated when I couldn't get the correct answer.

Thank you again!
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...

Similar threads

Replies
8
Views
2K
Replies
6
Views
4K
Replies
2
Views
2K
Replies
4
Views
2K
Replies
2
Views
10K
Replies
1
Views
2K
Replies
3
Views
2K
Back
Top