Projectile Motion-Shooting a Ball

  • Thread starter Thread starter atbruick
  • Start date Start date
  • Tags Tags
    Ball Projectile
AI Thread Summary
A ball is shot from a building at an initial velocity of 15 m/s at a 45-degree angle, requiring the calculation of its x and y components. The x component is found using cosine, while the y component uses sine, leading to values of approximately 10.61 m/s for both components. To determine how far below the top of the nearby building the ball will strike, the time of flight is calculated using horizontal motion, resulting in a time of about 5.36 seconds. The vertical motion equation must account for the correct signs, particularly for gravity, which is negative when considering upward as positive. Attention to detail in calculations and rounding is crucial for accurate results.
atbruick
Messages
20
Reaction score
0

Homework Statement


A ball is shot from the top of a building with an initial velocity of 15 at an angle = 45 above the horizontal. What are the x and y components of the initial velocity? If a nearby building is the same height and 59 m away, how far below the top of the building will the ball strike the nearby building?




Homework Equations


Trig equations of sin and cos
sinTheta=opp/hyp cosTheta=adj/hyp


The Attempt at a Solution


I thought the x component at initial velocity would be zero, and the y component was sin45=y/15, which I got to be 11; Either one of these or both are wrong, my homework doesn't tell me if one is right or not. Not sure how to approach this because I thought the sin for y was correct.
 
Physics news on Phys.org
If the x component of the initial velocity was zero then the ball would be traveling straight upwards. How have you calculated this?
 
oh opps so just like you calculated y by using sine use cosine to get x. Thank you! I also just tried to find the second part, the distance it hits below the roof; I needed to find t so I used X=Xo+Vxot, 59=0+11t, and got t to be 5.36. Then plugged that into Y=Yo+Vyot-.5at^2, and got Y=0+11(5.36)-.5(-9.80)(5.36^2) and got 200 which was wrong. What am I plugging in wrong in the equation?
 
I think you are using all the right equations but you need to be careful with minus signs.

If you are regarding upwards as positive (a good idea) then your expression for y should read:

<br /> <br /> Y=Y_0+V_y(0)+\frac{1}{2} a t^2<br /> <br />

Then you can consider in which direction acceleration due to gravity points.

Also watch out for rounding errors. You might find that you need more decimal places in your value for Vx and Vy.
 
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
Back
Top