Ratio of energy densities of black body radiation

AI Thread Summary
The discussion focuses on the ratio of energy densities of black body radiation, specifically comparing u(2ν) to u(ν). The initial formula for energy density is correctly stated, but participants note the need for simplification and the identification of a constant factor. After manipulation, the ratio simplifies to a form that leads to the conclusion that the answer corresponds to option (B). The final expression confirms the correctness of the calculations, leading to a consensus on the solution.
Pushoam
Messages
961
Reaction score
53

Homework Statement


upload_2017-12-31_14-4-30.png


Homework Equations

The Attempt at a Solution

The energy density is given as ## u = \frac { 8 \pi {\nu }^2}{c^3}~ \frac { h \nu} {e^{ \frac { h\nu}{k_B T}} – 1}.##

EDIT : I put the constant C.
## \frac { u( 2 \nu) } {u(\nu)} = C \frac { {e^{ \frac { h\nu}{k_B T}} – 1} }{ {e^{ \frac { 2h\nu}{k_B T}} – 1} } ##
Where C is the appropriate constant.

Is this correct?
 

Attachments

  • upload_2017-12-31_14-4-11.png
    upload_2017-12-31_14-4-11.png
    14.4 KB · Views: 599
  • upload_2017-12-31_14-4-30.png
    upload_2017-12-31_14-4-30.png
    6.4 KB · Views: 919
Last edited:
Physics news on Phys.org
Pushoam said:

Homework Statement


View attachment 217649

Homework Equations

The Attempt at a Solution

The energy density is given as ## u = \frac { 8 \pi {\nu }^2}{c^3}~ \frac { h \nu} {e^{ \frac { h\nu}{k_B T}} – 1}##.

## \frac { u( 2 \nu) } {u(\nu)} = \frac { {e^{ \frac { h \nu}{k_B T}} – 1} }{ {e^{ \frac { 2h \nu}{k_B T}} – 1} } ##

Is this correct?
The formula is correct (apart from a constant factor), but you have to simplify it and figure out which option it corresponds to. Note that ##e^{ \frac { 2h \nu}{k_B T}}=\left(e^{ \frac { h \nu}{k_B T}}\right)^2##
 
ehild said:
Note that ##e^{ \frac { 2h \nu}{k_B T}}=\left(e^{ \frac { h \nu}{k_B T}}\right)^2##

Thanks for this insight.
## \frac { u( 2 \nu) } {u(\nu)} = \frac { {e^{ \frac { h\nu}{k_B T} } – 1} } { \left ({e^{ \frac { h\nu}{k_B T}} – 1}\right ) \left( {e^{ \frac { h\nu}{k_B T}} +1} \right) } ## ## = \frac1 {e^{ \frac { h\nu}{k_B T}} +1} ##

So, the answer is option (B).
 
Last edited:
Pushoam said:
Thanks for this insight.
## \frac { u( 2 \nu) } {u(\nu)} = \frac { {e^{ \frac { h\nu}{k_B T} } – 1} } { \left ({e^{ \frac { h\nu}{k_B T}} – 1}\right ) \left( {e^{ \frac { h\nu}{k_B T}} +1} \right) } ## ## = \frac1 {e^{ \frac { h\nu}{k_B T}} +1} ##

So, the answer is option (B).
Yes :)
 
Thread 'Variable mass system : water sprayed into a moving container'
Starting with the mass considerations #m(t)# is mass of water #M_{c}# mass of container and #M(t)# mass of total system $$M(t) = M_{C} + m(t)$$ $$\Rightarrow \frac{dM(t)}{dt} = \frac{dm(t)}{dt}$$ $$P_i = Mv + u \, dm$$ $$P_f = (M + dm)(v + dv)$$ $$\Delta P = M \, dv + (v - u) \, dm$$ $$F = \frac{dP}{dt} = M \frac{dv}{dt} + (v - u) \frac{dm}{dt}$$ $$F = u \frac{dm}{dt} = \rho A u^2$$ from conservation of momentum , the cannon recoils with the same force which it applies. $$\quad \frac{dm}{dt}...
I was thinking using 2 purple mattress samples, and taping them together, I do want other ideas though, the main guidelines are; Must have a volume LESS than 1600 cubic centimeters, and CAN'T exceed 25 cm in ANY direction. Must be LESS than 1 kg. NO parachutes. NO glue or Tape can touch the egg. MUST be able to take egg out in less than 1 minute. Grade A large eggs will be used.
Back
Top