Refraction/Smallest curve of optical fibre.

AI Thread Summary
The discussion revolves around calculating the smallest radius (R) for bending an optical fiber without light escaping, given its diameter of 4mm and the refractive indices of air and glass. The critical angle is determined to be approximately 41.81 degrees using the formula involving the refractive indices. The participant struggles to form a triangle with sufficient information to apply sine or cosine rules for finding R. They propose using the relationship between angles and lengths in a right triangle, specifically relating R to the fiber's diameter. The conversation highlights the challenges in visualizing the geometry involved in the problem.
Berdi
Messages
12
Reaction score
0

Homework Statement



"figure 3" (below) shows an optical fibre bent in a curve. The diameter of the fibre is 4mm. If light is not to escape, calculate the smallest radius of R of the curve round which the fibre can be bent. Assume that the fibre is surrounded by air (refractive index 1) and that the refractive index of glass is 1.5"

Phys-1.jpg



Homework Equations



n1
___ = SinC (critical angle)

n2

The Attempt at a Solution



Well, I've got c, the critical angle -

1
__ = 0.666... sin-1(o.666) = 41.81
1.5

But, I can seem to make a triangle with enough information to get R. I've tried splitting it up, but either get not enough information to do sine or cosine rules, or a non right angle triangle. Maybe I'm just missing something?
 
Physics news on Phys.org
Call the acute angle at the centre between the dashed and dotted lines A.
If the fibre makes a quadrant then the angle between the incoming ray and the dotted line is 90 therefore angle A is 90-C.
The dotted line is length R, the hypotonuse (dashed line) is R+4mm and the angle is (90-c)
So cos(90-C) = r/(r+4mm)
 
So just rearrange that to give me R? Ill give it a shot.
 
I multiplied the values first without the error limit. Got 19.38. rounded it off to 2 significant figures since the given data has 2 significant figures. So = 19. For error I used the above formula. It comes out about 1.48. Now my question is. Should I write the answer as 19±1.5 (rounding 1.48 to 2 significant figures) OR should I write it as 19±1. So in short, should the error have same number of significant figures as the mean value or should it have the same number of decimal places as...
Thread 'A cylinder connected to a hanging mass'
Let's declare that for the cylinder, mass = M = 10 kg Radius = R = 4 m For the wall and the floor, Friction coeff = ##\mu## = 0.5 For the hanging mass, mass = m = 11 kg First, we divide the force according to their respective plane (x and y thing, correct me if I'm wrong) and according to which, cylinder or the hanging mass, they're working on. Force on the hanging mass $$mg - T = ma$$ Force(Cylinder) on y $$N_f + f_w - Mg = 0$$ Force(Cylinder) on x $$T + f_f - N_w = Ma$$ There's also...
Back
Top