Rotation direction of an ac induction motor

AI Thread Summary
The direction of rotation for single-phase AC induction motors can vary based on the wiring of the starting circuit, allowing for both clockwise and anti-clockwise operation. In contrast, three-phase AC induction motors can also run in either direction, depending on how the three phases are connected; reversing any two phases will change the motor's rotation direction. Some motors are designed with a switch to easily change the rotation direction. Improper wiring can lead to motors running in the wrong direction, causing operational issues. Understanding the wiring and configuration is essential for proper motor function.
samieee
Messages
67
Reaction score
0
I want to know that is the direction of a single phase or three phase ac induction motor is fixed and it is clockwise? ...or it may be both anti-clockwise and clockwise..or it can be both directional for single phase and only clockwise directional for 3 phase?...thanks
 
Engineering news on Phys.org
samieee said:
I want to know that is the direction of a single phase or three phase ac induction motor is fixed and it is clockwise? ...or it may be both anti-clockwise and clockwise..or it can be both directional for single phase and only clockwise directional for 3 phase?...thanks
Single phase motors can run either way,depending on how the starting circuit (capacitor start, split phase start, etc.) is wired.
Three phase motors can run either way depending on how the 3 phases are connected to the motor. I have seen vacuun pumps on large vacuum systems run backwards, because someone forgot how to wire up the motor phases.

Bob S
 
Some motors are designed so that the user can change the direction with a switch.
 
Three phase motors can run either way depending on how the 3 phases are connected to the motor.
Yes and just switch two phases and it will run in the opposite direction.
 
thanks... I got my answer
 
Bob S said:
Single phase motors can run either way,depending on how the starting circuit (capacitor start, split phase start, etc.) is wired.
Three phase motors can run either way depending on how the 3 phases are connected to the motor. I have seen vacuun pumps on large vacuum systems run backwards, because someone forgot how to wire up the motor phases.

Bob S

We did that once (cryopump compressor). It made a hell of a racket for the few seconds it was up while we were trying to figure out if that was the normal sound or not (though to be fair, the documentation just told us to hook it up, and switch two leads if we didn't think it was running properly).
 
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
Back
Top