Sandbag Dropped from Moving Balloon

  • Thread starter Thread starter Lycouras
  • Start date Start date
  • Tags Tags
    Balloon
AI Thread Summary
A hot air balloon ascends at 10 m/s when a passenger drops a sandbag from 40 m above ground. The acceleration due to gravity is -9.81 m/s², and the initial velocity of the sandbag matches the balloon's upward speed. The equation used to determine the time in the air is v1 = x0 + v0Δt + 0.5aΔt². After solving, it is confirmed that the sandbag stays in the air for approximately 2.86 seconds before hitting the ground. The discussion emphasizes the importance of using the correct initial velocity and omitting negative time values.
Lycouras
Messages
2
Reaction score
0

Homework Statement


Hey guys, I'm struggling on the following question:

Consider a hot air balloon traveling upwards at a constant speed of 10 m/s. A passenger drops a small sandbag over the side of the balloon when the balloon was 40 m above the ground. For how long does the sandbag stay in the air before falling to the ground?
Known:
a=-9.81 m/s2
x0=40 m
x1=0 m
v0=0 m/s
v1=?
t=?

Homework Equations


v1=x0+v0Δt+0.5aΔt2

The Attempt at a Solution


0=40+0.5(-9.8)Δt2
-40=-4.9Δt2
8.16=Δt2
Δt2=±2.86

Since time cannot be negative, it takes 2.86 seconds, is this correct? Thanks in advance.
 
Physics news on Phys.org
Lycouras said:
Consider a hot air balloon traveling upwards at a constant speed of 10 m/s.
...
v0=0 m/s

Since the balloon is moving upwards and the sandbag was dropped from the balloon, the initial velocity of the sandbag is the same as the velocity of the balloon. Other than that, you did everything right.
 
So from there you use the quadratic formula to solve for t, then again omit the negative answer? Thank you!
 
correct
 
Thread 'Minimum mass of a block'
Here we know that if block B is going to move up or just be at the verge of moving up ##Mg \sin \theta ## will act downwards and maximum static friction will act downwards ## \mu Mg \cos \theta ## Now what im confused by is how will we know " how quickly" block B reaches its maximum static friction value without any numbers, the suggested solution says that when block A is at its maximum extension, then block B will start to move up but with a certain set of values couldn't block A reach...
TL;DR Summary: Find Electric field due to charges between 2 parallel infinite planes using Gauss law at any point Here's the diagram. We have a uniform p (rho) density of charges between 2 infinite planes in the cartesian coordinates system. I used a cube of thickness a that spans from z=-a/2 to z=a/2 as a Gaussian surface, each side of the cube has area A. I know that the field depends only on z since there is translational invariance in x and y directions because the planes are...
Back
Top