Separation Through chromatography

AI Thread Summary
Chromatography, specifically paper and thin-layer chromatography (TLC), is primarily a separation technique used to analyze mixtures rather than for extraction. While TLC can indicate the presence of components in a mixture, it is not typically employed for extracting substances for further use. For effective separation and purification, column chromatography is recommended. In some cases, small amounts can be extracted from TLC or paper by cutting the stained area and using a solvent, but this is not the standard practice. An example shared involved using TLC for purifying nucleoside triphosphates, highlighting its utility in specific scenarios, although column chromatography is generally preferred for purification processes.
Deadevil
Messages
21
Reaction score
0
Dear all,
We all know that chromatography is a separation technique. In paper or TLC,the mixture is differentiated according to their relative affinities with the solvent on the paper or glass plate. How do we really separate the mixture. Kindly, help me how to extract the components of mixture from paper or TLC.
Thanks
 
Chemistry news on Phys.org
TLC is not typically used for extraction, rather to check what is present in the solution/how is the reaction going. If you want to separate substances for further use, use column chromatography.
 
  • Like
Likes SimOpera
You mean Paper and TLC..?
 
Yes.

In case small amount is enough, you can do the chromatography (TLC or paper), cut the stain and extract the substance in small amount of solvent. But in general that's not what TLC and paper chromatography is for.
 
Borek said:
Yes.

In case small amount is enough, you can do the chromatography (TLC or paper), cut the stain and extract the substance in small amount of solvent. But in general that's not what TLC and paper chromatography is for.

I often used to use TLC to purify nucleoside triphosphates , (DEAE-cellulose with NaCl eluant) - it was pretty simple, only small quantities were needed and you very easily see the bands of the triphosphates and of impurities by UV illumination. Just came back to me that before chromatogrphing the sample, we prepared the DEAE-cellulose plates putting the bottom of the plate in water or dilute salt and this pushed some stuff out of the DEAE which you could see as a dark band that moved with the front, then we dried them. Don't knows if many people would use it nowadays though.
 
I agree with Borek. Column chromatography is the way forward for typical purification processes. Let me know if you need help with that. :)

Cheers
 
I want to test a humidity sensor with one or more saturated salt solutions. The table salt that I have on hand contains one of two anticaking agents, calcium silicate or sodium aluminosilicate. Will the presence of either of these additives (or iodine for that matter) significantly affect the equilibrium humidity? I searched and all the how-to-do-it guides did not address this question. One research paper I found reported that at 1.5% w/w calcium silicate increased the deliquescent point by...
I was introduced to the Octet Rule recently and make me wonder, why does 8 valence electrons or a full p orbital always make an element inert? What is so special with a full p orbital? Like take Calcium for an example, its outer orbital is filled but its only the s orbital thats filled so its still reactive not so much as the Alkaline metals but still pretty reactive. Can someone explain it to me? Thanks!!
I'm trying to find a cheap DIY method to etch holes of various shapes through 0.3mm Aluminium sheet using 5-10% Sodium Hydroxide. The idea is to apply a resist to the Aluminium then selectively ablate it off using a diode laser cutter and then dissolve away the Aluminium using Sodium Hydroxide. By cheap I mean resists costing say £20 in small quantities. The Internet has suggested various resists to try including... Enamel paint (only survived seconds in the NaOH!) Acrylic paint (only...
Back
Top